How do you remove an impeller from a pool pump?
Use a wrench or a pair of pliers to hold the back end of the motor shaft steady, and turn the impeller counterclockwise to unscrew it from the shaft. You might have to use a strap wrench or something else soft to loosen it at first. If you’re having trouble, read my guide on removing a stuck pool pump impeller.
How do you remove a seal plate from a pump?
You will need to remove the impeller before you can remove the seal plate. Remove the old seal assembly – Using a pair of channel-locks, pull off the old pump spring seal from the motor shaft. Inside the center of the seal plate is the ceramic part of the pump seal. Be careful not to damage the plastic of the seal plate.
How to replace the seal on a swimming pool pump?
Steps Separate the pump housing – Most pumps have either a large metal clamp ring or a series of nuts and bolts the hold the pump housing to the motor plate. Using a socket or crescent wrench, remove the nut that is securing clamp together or loosen and remove the series of nuts and bolts.
How do you remove a clamp from a pump?
Using a socket or crescent wrench, remove the nut that is securing clamp together or loosen and remove the series of nuts and bolts. Some banded pumps have a hand knob instead of a nut holding the clamp together. Slide back the half of the pump assembly with the motor attached. Try to place the pump on a suitable work surface.
You will need to remove the impeller before you can remove the seal plate. Remove the old seal assembly – Using a pair of channel-locks, pull off the old pump spring seal from the motor shaft. Inside the center of the seal plate is the ceramic part of the pump seal. Be careful not to damage the plastic of the seal plate.
Using a socket or crescent wrench, remove the nut that is securing clamp together or loosen and remove the series of nuts and bolts. Some banded pumps have a hand knob instead of a nut holding the clamp together. Slide back the half of the pump assembly with the motor attached. Try to place the pump on a suitable work surface.
Steps Separate the pump housing – Most pumps have either a large metal clamp ring or a series of nuts and bolts the hold the pump housing to the motor plate. Using a socket or crescent wrench, remove the nut that is securing clamp together or loosen and remove the series of nuts and bolts.
How do you change impeller on seadoo spark?
Pull out the siphon tube (no need to take of the clamp) and remove the three bolts securing the pump to the pump support and pull rearwards to remove pump. 7. Remove the three bolts securing the venturi to the impeller housing.
