How do you remove a DE filter from your finger?

Grasp the finger at the very top and turn slightly clockwise. Pull the filter finger down and remove from the cover. Discard the finger. Repeat this process for any filter fingers that need to be replaced.

How often should de filter be cleaned?

once every month
You should clean your DE filter at least once every month or whenever you’re pounds per square inch is 8 to 10 pounds above the normal starting pressure. Cleaning your DE Filter involves three basic steps: Backwashing, Cleaning the manifold and grid and adding new DE.

What size DE pool filter do I need?

The filter flow rate must be rated at least the same GPM as your pump, or higher. With pool filters, it’s best to err on the larger size so it can handle the power of your pump. A helpful rule of thumb is to choose a filter with at least 1 square foot per 10,000 gallons pool capacity.

What are the names of the perflex pool filters?

Hayward Swimming Pool Products makes a D.E. pool filter called the Perflex EC-Series Swimming Pool Filter. They make a few different sizes of this Perflex pool filter. The different names of the EC filters are the EC-30, The EC-40, The EC-50 and The EC-65, which is the largest model of the EC-SERIES line.

How can I replace my Hayward perflex pool filter?

Once you have removed the two bolts you can remove the handle from the top of the Hayward Perflex Pool Filter tank. Now you will want to replace the handle with the new bump handle. To do so align the holes on the bump handle with the holes at on the filter tank and then push the bolt through.

Where are the O rings on the Hayward perflex filter?

If you have an old Hayward EC series filter with multiple bolts in the top you will want to make sure to tighten them down evenly to prevent leaks. On the bump shaft on the Hayward Perflex you will see two different o-rings.

What’s the difference between de and perflex filters?

The main difference is the grid assembly, called a “ Filter Nest ” on the Perflex filter. Dozens of flex-tube grids, often called “fingers”, are in stark contrast to the larger, flat panels of other de filter grid assembly designs.