How do you manually operate LCI electronic leveling?
How to Enter Manual Mode – Retract:
- Push “ON/OFF” to turn the system on.
- Push the “UP” arrow once, or until the screen reads “MANUAL MODE”.
- Push the “ENTER” button once.
- Push the “RETRACT” button, the red LED light will turn on.
- Push the “REAR” button to retract all of the middle and rear landing gear legs.
Why does my Lippert LCI leveling system not work?
My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks.
Why is there no power on my LCI?
If nothing is getting power I’m wondering if your trailer itself is getting power. If your batteries are depleted and you don’t have your trailer electrical connected to your tow vehicle then there isn’t any power getting to your trailer and is makes sense that nothing is working.
How can I check the fluid level on my LCI?
Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink. Trans fluid level is hard to check as it is transparent on the dip stick. But the see through fluid tank shows level is about an 1-1/4 in below top of tank.
Why is the touch screen on my LCI not working?
Small red lights are on. None of the buttons work. Received new touch pad but no difference. The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue.
Why is my Lippert ground control leveling not working?
I dont know if the leveling system is a 2.0 or 3.0. The display on the touch pad is blank. The back light comes on, but no words, It seems like everything else works, I can press the auto level button and it works. I can press the retract button and retract the landing jacks, I just cant see anything on the display.
How does the Lippert electronic leveling system work?
The Lippert Electronic Leveling System is an electric/hydraulic system. A 12V DC electric motor drives a hydraulic pump that moves fluid through a system of hoses, fittings and jacks to level and stabilize the coach. The Lippert Electronic Leveling System is totally integrated into the chassis of the coach at the manufacturer.
If nothing is getting power I’m wondering if your trailer itself is getting power. If your batteries are depleted and you don’t have your trailer electrical connected to your tow vehicle then there isn’t any power getting to your trailer and is makes sense that nothing is working.
What should I do if my leveling jacks are not working?
Silicones and cleaning agents such as Dawn dish soap can worsen the corrosion and render your system irreparable. So what you should do is spray the system well with WD-40 and then wipe clean.
