How do you lock a Raypak pool heater?
This is the instructions from Raypak to lockout the controls: “Press the DOWN button and MODE button for 5 seconds. Choose a three digit PIN, using the UP and DOWN buttons to select the digits and the MODE button to lock in selections. Confirm your selection and record your PIN.”
How do I lock my AquaCal heat pump?
Press the [POOL/SPA] key once to display [ULC]. With [ULC] displayed, pressing either the Up or Down Arrow key will display either “1” or “0”. Selecting “0” will allow the keypad to remain unlocked. Selecting “1” will enable the User Lock Code option.
How does the fault code work on a Raypak pool heater?
The majority of Raypak heaters will have a digital readout. The digital readout helps pool owners read error codes on the actual heater. The models with digital thermostats are programmed to display a variety of status and diagnostic messages, depending on the operating conditions. They are also equipped with onboard diagnostic controls.
How do you exit the Raypak pool remote?
1) Press and hold up and down arrow buttons for 3 to 5 seconds. 2) The display format will indicate REMOTE on top line of display. 3) Press and hold up and down arrow buttons to exit REMOTE. What is A.S.M.E. ?
How do I Turn Off the lockout on my pool heater?
Press the “Mode” button, and cycle to the “Standby” setting. Press and hold the “Up” and “Down” buttons simultaneously. Hold the buttons until the indicator light rapidly flashes and the digital display shows the maximum temperature-lock setting.
What’s the maximum temperature lock on a pool heater?
Press and hold the “Up” and “Down” buttons simultaneously. Hold the buttons until the indicator light rapidly flashes and the digital display shows the maximum temperature-lock setting. Typically, this is in the range of 90-degrees F. Release both buttons.
How does a Raypak pool and spa control work?
2) If three lockouts occur in one heat demand, control goes into “hard lockout” and power must be removed and re-applied to reset. Your heater is equipped with a microprocessor-controlled thermostat that controls the pool or spa temperature by measuring the temperature of the water coming back through the heater.
What to do if your Raypak pool heater goes bad?
1. Possible excessive water temperature in the tube bundle. Once heater cools, high limits resets automatically. 2. Check for blockage in tubes. 3. Check for low water flow. 4. Check Unitherm governor- replace if necessary 1. Possible excessive water temperature in the tube bundle. Once heater cools, high limits resets automatically. 2.
When does the fault code appear on a Raypak heater?
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
How does the lockout work on a pool heater?
Digital controls for pool heaters have an ignition lockout function that automatically maintains a particular water temperature. If the temperature inadvertently changes or isn’t constant, there may be a problem with the controls, or the lockout function needs to be reset.
