How do you install an acrylic bathtub?
Use a spirit level to ensure that the floor is level. Remember that the acrylic bathtub must be fitted in a manner that will allow the water to run from it and flow down the drain. With that in mind, ensure that you correctly position the supports that come with a tub that is to be fitted.
How does an acrylic tub need to be supported?
The tub is designed to install in a recess, where three walls are comprised of stud framing, with the fourth acrylic wall exposed. An acrylic tub is not self-supporting, which means it must be supported along its entire bottom with mortar or grout.
How do you install stringers on a tub?
Once the wall framing is complete, horizontal stringers should be installed across the studs to support the edge of the tub deck. Mark their position by tracing a level line onto the studs at the height indicated in the tub’s instruction manual. Align the top of each stringer and nail or screw them to the studs.
Can a cast iron tub be replaced with an acrylic tub?
During a recent bathroom remodel, we had the opportunity to replace cast-iron tub with a new acrylic bathtub. Tubs are available in a number of different designs, and this project covers the American Standard Saver Tub (available at Lowe’s), which is designed to be installed in an alcove and surrounded on three sides by stud walls.
How do you install a drain flange on a bathtub?
Clean drain area, making sure to remove all old putty residue. Allow to dry before beginning installation of the new drain flange. Underneath the tub will be a rubber gasket that creates a seal for the drain elbow. Check this gasket to make sure it is in good shape. If it’s not, you’ll need to replace it (available below).
How do you install a freestanding bathtub?
APPLY LUBRICANT TO THE TAILPIECE Turn the tub upside down for an easy installation. Ensure you have the correct Waste & Overflow. Once the tailpiece is been installed on the waste & overlow, position the Tub and tailpiece in-line with the drain.
What’s the best way to remove a bathtub drain?
A rubber gasket underneath the tub seals the drain elbow to the tub. That drain elbow connects to a length of pipe that then connects to the waste and overflow pipe. Tools needed: Drain Key or Smart Dumbell tub drain removal tool. Flathead screwdriver (may be needed to remove the stopper) Wrench. Bucket or container.
How to install a valley acrylic bathtub?
Thank you for choosing Valley Acrylic Bath. This installation manual provides general information on the installation of our products. All the information in this guide is based upon the most recent product information available at the time of this publication.
