How do you extend Atwood Levelegs?
Press the ON button. For each jack, hold down the EXT button and press the two buttons adjacent to a corner for ten seconds to extend each jack slightly. Have someone watch the jacks and make sure they all move. Press and release the RET and ALL buttons together to bring the jacks back up.
How to reset atwood Leveling system?
To proceed, the following is required:
- Turn system on. This will shut the warning alarm off.
- Visually inspect the leveler.
- If it is required, activate levelers to correct problem. Simultaneously press the EXTEND or RETRACT mode.
- Complete an ALL RETRACT operation and system is now.
How to retract jacks on Atwood levelegs system?
Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated. Press RET and ALL to retract all jacks. 2 RED AND GREEN LIGHTS COME ON FOR A SPECIFIC JACK LOCATION Cause:
How do you extend an Atwood camper Jack?
Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated. Press RET and ALL to retract all jacks.
Is the Atwood levelegs grounded on the same bus?
It could be a poor ground, but according to the diagram, all four motors are grounded on the same buss. Check voltage with a digital voltmeter at the control panel while deploying the jacks. If 12+VDC, I would suggest giving Atwood a call at 800-546-8759.
What are the flashing lights on my Atwood levelegs?
Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.
Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated. Press RET and ALL to retract all jacks. 2 RED AND GREEN LIGHTS COME ON FOR A SPECIFIC JACK LOCATION Cause:
It could be a poor ground, but according to the diagram, all four motors are grounded on the same buss. Check voltage with a digital voltmeter at the control panel while deploying the jacks. If 12+VDC, I would suggest giving Atwood a call at 800-546-8759.
What causes short Jack extension on Atwood camper?
Cause: Short jack extension followed by jack retraction. Solution: Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack.
Where can I get an Atwood Awood controller?
Atwood Tech Service is GREAT! Do not hesitate to call if you have an Atwood problem. Other RV product mfgs. should emulate them. I need an Awood controller 66235 as mine will no longer work. Can anyone help me either repair this one or get one from a salvage yard?
