How do you drain water from a sapphire spa?

Locate the drain valve towards the base of your spa cabinet and pull cap out from the housing approximately 2” until it snaps into place. Depending on bather usage and the type of sanitising system used, your Sapphire Spa needs to be drained regularly every two to four months.

What does no temp data mean on sp800?

Error 8 (“NO TEMP DATA”) – No Temperature Data This error indicates a problem with the digital temperature sensor in the heater or pool wall. The sensor may have become disconnected or damaged. Try to reset the spa. If there is still a problem then contact your spa pool supplier.

Why is my sp800 pool not working properly?

This may not be a problem with the SP800. It may be caused by excessive pump use in hot weather or pump failure. Turn off the spa and allow time for the water to cool then If there is still a problem then contact your spa pool supplier.

How do you reset the sp800 and SP1200?

To Reset the SP800 & SP1200 wait a minimum of 20 minutes to allow the heater tube to cool. Then press the two light buttons and the blower (SP800)/pump2 on/off (SP1200) and pump1 on/off button all simultaneously and hold for 3 seconds.

What to do if your sp800 heater has cut out?

Turn off the spa and allow time for the water to cool then If there is still a problem then contact your spa pool supplier. Error 6 (“THERMAL CUT OUT”) – Thermal Cut Out Tripped This error indicates that the safety electromechanical over temperature cut out on the heater has operated. This is not necessarily a problem with the SP800.