How do you drain a Balboa?

How do you drain a Balboa?

How to Drain a Balboa Hot Tub

1. Switch the circuit breaker connected to your Balboa hot tub to the “Off” position. If you are unsure as to which breaker correlates to the hot tub, turn off the main breaker.
2. Remove the cover from the front of the drain spigot.
3. Run the hose to a drain or onto your lawn.

Are there any manuals for a Balboa hot tub?

There are many manuals for Balboa control systems, and we do not have them all, however the following should help if you are replacing, installing, servicing or upgrading a Balboa Circuit Board.

Is it safe to replace a Balboa hot tub heater?

Although they are extremely good at what they do, they are not immune to breaking. This article will discuss how to troubleshoot your Balboa hot tub heater. It is important to note that it is never safe, or a good idea to replace a spa heater element.

What does SL mean on a Balboa hot tub?

Sleep Mode (sl) = heats to within 10 degrees (less) than preset temperature and only during the filtration cycle. Filtration Cycles run from F1 to F8 (F1 = 1 hour every 12 hours / F8 = 8 hours every 12 hours). Preset cycle set from factory is F1, so if in ec or sl mode your water will not reach desired temperature.

How to exit rest mode on a Balboa?

TO EXIT REST MODE:- Press Temp, then press light repeatedly until ‘MODE’ appears in the LCD. Toggle between READY and REST by pressing temp. Press light or wait for 10 seconds to go back to the Main Screen. Sleep Mode (sl) = heats to within 10 degrees (less) than preset temperature and only during the filtration cycle.

Why does my Balboa hot tub have an error code?

If this happens five times in a 24 hour period it will trigger the error code and disable the heater. Blocked suctions. All hot tubs have suctions in the foot well area where they suck water from to pump through the Balboa heater and to the jets.

Can a Balboa hot tub heater be reliable?

It can be difficult to find a heater that is reliable and has the longevity that the majority of hot tub heaters lack. Although they are extremely good at what they do, they are not immune to breaking. This article will discuss how to troubleshoot your Balboa hot tub heater.

When does a Balboa hot tub go into priming mode?

With Balboa and other brand hot tub controls, upon startup, after a power outage or upon restarting the spa, the pump will go into a priming mode before the spa starts up. This can be about 4 minutes on many models with Balboa controls. PR or priming code will appear in the display.

Why is my Balboa hot water heater disabled?

The Balboa spa pack has detected this fault 5 times in the last 24 hours or less, and the heater is now disabled. This fault has typically occurred as a result of not enough water flow through the heater to carry the hot water away from the heating element.