How do you disconnect the water line from a copper refrigerator?
Use pliers to grab the metal nut on the end of the copper pipe where it connects to the back of your freezer. Twist the nut counterclockwise to loosen the connection, then pull the pipe out of the freezer.
What’s the best way to remove an ice maker?
Step 1 – Protect Yourself. Begin the ice maker removal process by unplugging your refrigerator and making sure that the ice maker’s water supply has been safely shut off. This can usually be accomplished by shutting off the appropriate valve on your refrigerator’s water line, but just to err on the safe side, consult your refrigerator’s owner’s…
How do you check out an ice maker?
1. Remove the ice bin and shelf. 2. Remove the two 5/16″ mounting screws. 3. With a Phillips screwdriver, remove the 2 screws under the Ice Maker. 4. Pull Ice Maker forward to remove. 5. Remove white cover plate. 6.Follow Check Out procedures. Wire Harness Check – Figure 6 The wire harness has a thermal fuse.
What are the trouble shooting procedures for an ice maker?
Trouble Shooting Procedures. These check-out procedures are based on: * 12 Volts DC (Control Voltage) is available to the Refrigerator. * 120 Volts AC is available to the refrigerator and to the Ice Maker. * Water pressure to the Ice Maker is at 15 psi min.
What causes an ice maker to stop making ice?
Other problems include an ice maker that won’t stop making ice or freezes up. Here we begin with the most common problem—the ice maker stops making ice. Make sure the bail wire above the ice tray is in the down position. When it’s up, it shuts off the ice maker.
How do you remove an ice maker from a freezer?
Use a slot screwdriver to release the locking tab on the wire harness plug and pull the wire harness out of the plug. Remove the ice maker from the freezer compartment. Close the freezer door. PHOTO: Remove the ice maker from the rails to access the wire harness.
How do you remove ice maker from rails?
Using a 1/4-inch nut driver, remove the screw that’s under the ice maker module, in the rear right corner. Pull off the cover that the screw held in place. Set the screw and plastic cover aside. 04. Push in on the tab to the left of the ice maker to release the ice maker and slide the ice maker forward, off its rails.
1. Remove the ice bin and shelf. 2. Remove the two 5/16″ mounting screws. 3. With a Phillips screwdriver, remove the 2 screws under the Ice Maker. 4. Pull Ice Maker forward to remove. 5. Remove white cover plate. 6.Follow Check Out procedures. Wire Harness Check – Figure 6 The wire harness has a thermal fuse.
What should I do if my ice maker is not working?
Use a volt ohmmeter and check for 120 volts AC between test points L and N. Note: Insure your meter leads contact the surfaces of the test points. If 120 volts is present, proceed to “Water Valve” check out. If 120 volts is not present, replace the ice maker’s wir- ing harness. FIGURE 1 FIGURE 2 C503
