How do you clear the error code on a LCI leveling system?
How to Clear Retract Time Out Return Levelers Error on LCI Level Up System If the touch pad is showing “Retract Time out Return Levelers for service” all you need to do is hit, enter and retract at the same time. That will clear that code.
How do you override a LCI level?
You can do this by simply turning your system on and pressing the “FRONT” button. Have the pad soaped up and aligned properly under your jack and continue to press the button until you hear the “snap”. Once the front two pads are installed, you can unhitch and enter manual mode in your LCI Level Up® System.
Why does my Lippert LCI leveling system not work?
My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks.
Which is the right button on the LCI?
The “FRONT” button controls both left and right front jacks. The “LEFT” button controls the middle jack and rear jack on the driver’s side. The “RIGHT” button controls the middle jack and rear jack on the passenger’s side.
How do I Turn On my LCI system?
Push the “LEFT” button to extend the driver’s side middle and rear jack. When pressing this button the middle jack will extend first then the rear. Push the “RIGHT” button to extend the passenger’s side middle and rear jack. When pressing this button the middle jack will extend first then the rear. Push “ON/OFF” to turn the system on.
How to control the LCI leveling system in a RV?
Push the “REAR” button to extend the middle and rear landing gear legs. Push the “LEFT” button to extend the driver’s side middle and rear jack. When pressing this button the middle jack will extend first then the rear. Push the “RIGHT” button to extend the passenger’s side middle and rear jack.
Why is my LCI leveling system not working?
My lci electronic leveling system for winnabago has Jacks down and is indicating low voltage but I know that the batteries are fully charged and prior to shut down indicated 13.6v. This sounds like it is a ground issue. If your ground wire from the control module is grounded to the frame, I would try removing the ground and cleaning the surface.
How can I Reset my Lippert LCI leveling system?
My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink.
Why is there a blank screen on my LCI?
The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue. I recommend first remove the panel and unplug it from the back leaving it unplugged for at least 15 minutes so that it loses all of the residual power and is completely shut off.
Why is my Lippert ground control leveling not working?
I dont know if the leveling system is a 2.0 or 3.0. The display on the touch pad is blank. The back light comes on, but no words, It seems like everything else works, I can press the auto level button and it works. I can press the retract button and retract the landing jacks, I just cant see anything on the display.
