How do you clean a Jandy salt sensor?
Remove the cell from the Jandy AquaPure Purification System. Remove the sensor from its port on the cell if scaling is detected. Wash the cell well with water. Turn the flow/temp/salinity sensor counterclockwise to remove it from the three-port cell.
How do you recalibrate Aqua pure salt?
Press and hold the ‘Pool Temperature’ (‘D’) key for 15 seconds. The system will beep when the button is pushed, it will beep again after 10 seconds, and again after 15 seconds. Release the key after the third beep. Press ‘Salinity’ (‘C’) key within 5 seconds to enter temperature change screen.
How do you calibrate Aqua Pure?
Press and hold the ‘Pool Temperature’ (‘D’) key for 15 seconds. The system will beep when the button is pushed, it will beep again after 10 seconds, and again after 15 seconds. Release the key after the third beep.
What are the problems with my Jandy aquapure 1400?
I did replace the salt generating cell for my Jandy Aquapure 1400 about two years ago from the square model to the circular model. Over the winter it is flushed and cleaned by my pool company. Now it is giving me additional problems. I first noticed a few days ago that it had an error code – service code 121.
Can a Jandy plc1400 sensor be replaced?
BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine. I have found that I get better performance if I clean the sensor ever couple of months. BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine.
What should I do if my Jandy pool sensor dies?
Make sure you get the PLC1400 kit with sensor and cable. It will be an easy switch, just plug and play type of thing. Do not cut the cable, do like you are saying and wrap the cable up and leave the sensor in place just in case you need to use it if a sensor dies on you.
When does the zodiac aquapure salinity sensor come out?
Tri-Sensor R-kits will ship first, beginning with date code 10/6/14. A separate communication will follow regarding the release timing for finished goods (complete PLC cell kits and FSOFT kits) once they start shipping with the new Tri-Sensor. Part numbers and pricing are not affected.
I did replace the salt generating cell for my Jandy Aquapure 1400 about two years ago from the square model to the circular model. Over the winter it is flushed and cleaned by my pool company. Now it is giving me additional problems. I first noticed a few days ago that it had an error code – service code 121.
BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine. I have found that I get better performance if I clean the sensor ever couple of months. BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine.
Make sure you get the PLC1400 kit with sensor and cable. It will be an easy switch, just plug and play type of thing. Do not cut the cable, do like you are saying and wrap the cable up and leave the sensor in place just in case you need to use it if a sensor dies on you.
Tri-Sensor R-kits will ship first, beginning with date code 10/6/14. A separate communication will follow regarding the release timing for finished goods (complete PLC cell kits and FSOFT kits) once they start shipping with the new Tri-Sensor. Part numbers and pricing are not affected.
