How do you clean a Hayward AquaRite salt cell?
WRITTEN BY: Inyo Pools With daily use hard mineral deposits will build up on the electrolytic plates of the cell. The manufacturer recommends checking the Hayward AquaRite Turbo Cell 3-4 times a year and cleaning it with a solution of water and muriatic acid to descale any deposits as required.
What do you clean a salt cell with?
Mix a 4:1 solution of water and muriatic acid in a bucket (one quart of acid to one gallon of water). Always add acid to the water, not the other way around. Connect the salt cell to a cell stand and pour the muriatic acid solution into the unit. Let the cell soak for 15-20 minutes.
How to reset aquarite salt chlorination inspect cell light?
Reset AquaRite Salt Chlorination Inspect Cell Light. If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
What’s the best way to clean an aquarite cell?
Instructions We strongly recommend using a Goldline Controls cell cleaning stand. (GLX-CELLSTAND) Step 1: Use a water hose to dislodge small debris. Step 2: Use a non-metal (plastic or wood), non-abrasive tool to dislodge minor calcium buildup and small debris. Step 3: Use a solution of water and Muriatic acid.
When to replace a Hayward Aqua rite salt cell?
This unit had a failed temp sensor inside and needed to be replaced as that is not a repairable part. It is always best to go with the largest salt cell — the T-15 is rated for 40,000 gallons even if your pool is much smaller. The cell will not have to work as hard and will last longer.
How to reset the average salt level on aquarite?
How to Reset Average Salt Level The Average Salt level needs to be reset for start up and when a cell is replaced. (factory default is 2800ppm) To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds).
How do you clean an aquarite Turbo cell?
Your first step in cleaning the Hayward AquaRite Turbo Cell is to turn off the power to the pump and Chlorine Salt Generator. Ideally this should be done at the circuit breaker. Next, relieve the water pressure in the pool line.
Instructions We strongly recommend using a Goldline Controls cell cleaning stand. (GLX-CELLSTAND) Step 1: Use a water hose to dislodge small debris. Step 2: Use a non-metal (plastic or wood), non-abrasive tool to dislodge minor calcium buildup and small debris. Step 3: Use a solution of water and Muriatic acid.
If it does then the problem is with your salt cell and it will be time to replace. If the temperature does not drop then the problem is with your circuit board. For more detailed information about the sensor and Hayward Salt Chlorinating Systems you can always reach Hayward directly at 908-351-5400 ext. 7961.
Reset AquaRite Salt Chlorination Inspect Cell Light. If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
