How do you calibrate a Jandy salt sensor?

Press the “Salinity”button and hold it until it beeps 3 times. The system will beep when you push it and then at 5 seconds and again at 10 seconds. Release the button after the 3rdbeep. Press and release the “Temperature “button within 5 seconds to enter the salinity calibration screen.

How much does a Jandy 1400 Aqua Pure salt cell cost?

This is the Jandy 1400 Aqua Pure Salt cell. This unit has a failed R0452500 OEM Salt Flow/Temperature/Salinity Sensor at the time of this cleaning (Error code 172, 186). You can get the sensor online for about $200.00.

How to fix Zodiac Jandy ei aquapure salt system?

How to fix a Zodiac Jandy Ei salt system cell with a no flow and yellow light blinking. Just make sure to clean pump strainer and filter to make sure the water is flowing through the cell and make sure you turn off the electricity before doing any repairs.

Why does my Jandy aquapure have no flow?

My Aquapure sensor was less than one year old and it started reading “No Flow”. I replaced the filter (it was time, anyway), cleaned the trap, scrubbed the sensor, inspected the salt cell, increased the RPMs, powered down & restarted the system, and just about every other troubleshooting trick I could find.

What is the temperature code on the Jandy flow sensor?

Now getting the magic 172/185 code “flow salinity sensor temperature probe error codes”. I’m on my 15th minute of hold for Jandy tech support (once again) to see if there are further tests I can run or if the flow sensor is defective as suggested in the manual.

Which is salt water pool purifying system does Jandy use?

Jandy Pro Series AquaPure is a heavy-duty, electronic saltwater swimming pool purifying system that uses ordinary salt to produce chlorine for salt water swimming pools.

How to check for no flow on Jandy aquapure 1400?

Test the temp of the pool then compare it to the read out from the a/p. Also take a water sample to a pool place and have them test it for salinity (not using test strips) and compare that to the a/p readings. Finally, camp out in front of the unit and wait to see if it gives you a three number fault code. If you call Jandy, dont expect much help.

Can a Jandy plc1400 sensor be replaced?

BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine. I have found that I get better performance if I clean the sensor ever couple of months. BEST ANSWER: I have a Jandy PLC1400 and replaced my old sensor with this one. It works fine.