How do you attach an actuator?
INSTALLATION
- Manually open valve.
- Remove valve mechanical stops.
- Check again that the valve and actuator are in the same position.
- Install mounting hardware on valve, do not tighten bolts securely at this time, mount actuator to valve, and once actuator screws have been started securely tighten all nuts and bolts.
How does the Jandy valve actuator ( JVA ) work?
This video show the Jandy Valve Actuator (JVA) which works with the control systems, such as the PDA. There is also some troubleshooting included which describes how to reset the JVA after they have been disengaged for the winter. Loading…
What is the voltage of a JVA 2444 valve?
JVA 2444 Specifications Voltage 24 VAC Amperage 0.75 AMPS Cycles 60 Hz Wire Black Red White 3-conductor Common Switch Leg Switch Leg Figure 2. Standard JVA Mounting A B (Common Port) C A B (Common Port) C Figure 1.
Is it OK to use inauthentic Jandy replacement parts?
Use Genuine Factory Parts—It Does Matter! Using genuine Jandy factory replacement parts helps to ensure the ongoing quality and reliability of our products. Plus, the use of inauthentic parts voids all factory warranties. Inauthentic parts may appear to be suitable on the surface, but they often fall short of factory standards.
Are there valve actuators for automatic pool systems?
Valve Actuators are designed to meet the needs of today’s more advanced, automatic pool equipment. These fully adjustable actuators offer versatile pool/spa automation with easy setups. All actuators work with AquaLink®RS Control Systems and are available in 24 volt units.
What kind of valve actuator does Jandy use?
Jandy Pro Series 2440 valve actuator designed for use with 2-port and 3-port valves. Prevents dead-heading of pumps. Corrosion-proof enclosure with external service switch.
JVA 2444 Specifications Voltage 24 VAC Amperage 0.75 AMPS Cycles 60 Hz Wire Black Red White 3-conductor Common Switch Leg Switch Leg Figure 2. Standard JVA Mounting A B (Common Port) C A B (Common Port) C Figure 1.
Valve Actuators are designed to meet the needs of today’s more advanced, automatic pool equipment. These fully adjustable actuators offer versatile pool/spa automation with easy setups. All actuators work with AquaLink®RS Control Systems and are available in 24 volt units.
Where is the plumbing position on a JVA?
3.1 Standard JVA Position Standard Plumbingposition is with the middle port (B) as the incoming or common port to the valve (see Figure 1). Standard Mountingposition is with the main body of the actuator over port B (see Figure 2).
