How do u get a hot tub out of sleep mode?
Now, you could simply hit the temperature down button a couple dozen times when you won’t be using your hot tub for a spell, but then you also have to do the same button-tapping process to raise the temperature.
How do I get my Viking spa out of sleep mode?
Press the “Jets” button once to activate the low speed of the pump and again for the high speed. Press the “Jets” button again to turn off the pump. If left running, the low speed of the pump will automatically turn off after 4 hours, and the high speed will automatically turn off after 15 minutes.
What to do when your hot tub is in sleep mode?
It normally requires the pressing of a couple of buttons on the control panel. One thing to keep in mind while using sleep mode is that your hot tub’s filtration system will only be working every so often.
What to do if your spa clock is not working?
Try to reset the spa. If there is still a problem then contact your spa pool supplier. Error 9 (“CLOCK FAULT”) Real Time Clock Failure This error indicates a problem with the real time clock within the SP800. Try to reset the spa. If there is still a problem then contact your spa pool supplier. manually push the 1 buttons simultaneously.
Why is my spa not working in hot weather?
It may be caused by excessive pump use in hot weather or pump failure. Turn off the spa and allow time for the water to cool then If there is still a problem then contact your spa pool supplier.
What to do if your hot tub control panel is not working?
Examine the panel to see if any moisture is inside the display. See if the panel or any buttons are cracked or if it could have possibly gotten wet. If only part of the control panel is not working, check for any blinking lights or error messages.
What does it mean when your Spa is in sleep mode?
“Ec” or “Ecn” will appear solid when the temperature is not current and will alternate with the temperature. Sleep mode heats the spa to within 20 F (11 C) of the set temperature only during filter cycles. “Sl” or “SLP” will appear on the display until mode is changed.
How to get a hot tub to exit SL sleep mode?
On them you need to press the ‘TEMP’ button and then the ‘LIGHT’ button within three seconds of each other and this will change the modes from EC (economy mode), to SL (sleep mode) and finally to ST (standard mode) which is what you want. Read full interaction below » Ask Your Own Pool and Spa Question Share this conversation Resolved Question:
How does sleep mode work on Viking spa?
Sleep Mode heats the spa to within 20°F/10°C of the set temperature only during filter cycles. “SL” will display solid when temperature is not current, and will alternate with temperature when temperature is current. Preset Filter Cycles. The first filter cycle begins 6 minutes after the spa is energized.
It may be caused by excessive pump use in hot weather or pump failure. Turn off the spa and allow time for the water to cool then If there is still a problem then contact your spa pool supplier.
