How do I unlock Tiger spa?

How to Unlock Tiger River Spa Controls

Tap the “MODE ^” button until “TOOLS” appears on the screen.
Tap “MODE ^” until “SPA -” is shown on the display.
Press “OFF V.” Use the spa controls as normal.
Tap the “MODE ^” button until “TOOLS” appears on the screen.
Tap “MODE ^” until “LOCK -” is shown on the display.

How to deactivate the spa lock on a hotspring?

To deactivate the SPA LOCK, press the LIGHT minus (-) and TEMP minus (-) buttons at the same time and hold them down until the word SPA and the lock symbol are no longer illuminated on the display (approximately two seconds). The TEMPERATURE LOCK feature deactivates the temperature control function of the main control panel.

How do you turn on the spa light?

To turn on the spa light, press the LIGHT plus (+) button. The light will turn on at maximum intensity and the light symbol will illuminate on the control panel display. To reduce the intensity of the light, press the LIGHT minus (-) button.

What are the installation instructions for hotspring Vista?

Page 28 INSTAllATION INSTRUCTIONS 1. To connect the electrical service, first open the equipment compartment door. Carefully pull the door panel away and remove it from the spa. 2. Locate the IQ 2020 spa control box. Loosen the screws on the front of the control box. Remove the screws and the control box cover. 3.

What to do if your hot spring spa lights keep blinking?

Turn power to the spa off for 1 minute, then turn power back on. For 240 v spas, turn on the 20 amp breaker and then turn on the 30 amp breaker. For 120 v spas, plug in. If light continues to blink, Call our Spa Service Department for a service call. 413-594-2666 ext 110 My Hot Spring Spa has blinking Green and Red lights.

How to test the circuit breakers on a vista hotspring?

Once your spa has been filled with water, turn it on and test all of the circuit breakers. ® ® ® ® Vista (SS),Grandee (GG), Envoy (KK),& Aria (AR) 230 volt permanently connected model… NeveR CONNeCT THe SPA TO AN eXTeNSION CORd! A pressure wire connector is provided on the exterior surface of the control box, inside the spa.

How do you airlock a hot spring spa?

To minimize airlocks in the equipment, put hose down the center of the gray standpipe in the filter compartment on a Hot Spring Spa. Turn hose on. This will fill the tub through the heater, pumps and jets pushing most of the air out of the lines. Fill the spa to the top of the highest jets.