How do I unlock my Jandy pool pump keypad?

Press and hold both arrow keys to unlock the keypad. Pressing and holding both arrow keys again will lock it again.

Is the JEP-R variable speed pump digital controller Rev D?

JEP-R Variable-Speed Pump Digital Controller WARNING H0412200 Rev D FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and ualified in pool euipment by the jurisdiction in which the product will be installed where such state or local reuirements exist.

When to install a jandypump variable speed pump?

WARNING Due to the potential risk of ﬁ re, electric shock, or injuries to persons, JandyPumps must be installed in accordance with the National Electrical Code (NEC), all local electrical and safety codes, and the Occupational Safety and Health Act (OSHA).

Is the Jandy Pro Series fhpm pump safe?

Page 4 ENGLISHJandy Pro Series FHPM Pump ® | Installation Operation Manual SAVE THESE INSTRUCTIONS WARNING Chemical spills and fumes can weaken pool/spa equipment. Corrosion can cause filters and other equipment to fail, resulting in severe injury or property damage. Do not store pool chemicals near your equipment. CAUTION

How much horsepower does a Jandy pool pump have?

EQUIPMENT INFORMATION RECORD DATE OF INSTALLATION INSTALLER INFORMATION INITIAL PRESSURE GAUGE READING (WITH CLEAR FILTER) PUMP MODEL HORSEPOWER NOTES: Section 1.

Is the Jandy Jep-R a good variable speed pump controller?

The JEP-R overall is a good controller for your Jandy Variable speed (VS) pump. The JEP-R can hold two schedule speed programs and up to a total of eight different speeds. This is where it can be confusing.

How long does a variable speed pool pump run?

4 – 4:30 a.m. High speed (3450 RPMs to ensure the pump sufficiently primes- non-peak hours) The total run time is 14 hours. I run my pump this long because I live in Florida and it is consistently hot. In colder states, you probably wouldn’t have to run the pump as long.

Can a Jandy pool pump be pressure tested?

Local codes may require the pool piping system to be subjected to a pressure test. These requirements are generally not intended to apply to the pool equipment, such as ﬁ lters or pumps. Jandypool equipment is pressure tested at the factory.

What should I do before installing a variable speed pump?

If, however, the WARNING cannot be followed and pressure testing of the piping system must include the ﬁ lter and/or pump, BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS: • Check all clamps, bolts, lids, lock rings, and system accessories to ensure they are properly installed and secured before testing.