How do I unlock my Hayward configuration menu?
Press the ‘Menu’ until, ‘Configuration Menu-Locked’ appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from ‘Locked’ to ‘Unlocked’ (unit will beep).
How do I reset my Hayward panel?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do you reset a Hayward Aqua Logic salt cell?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus (+) key once. This should reset the light and message. Lastly, follow the instructions on page 16 to reset the salt level after cleaning the cell.
How do I unlock Hayward?
How to unlock flow control on Prologic Hayward?
Press the Menu until, Configuration Menu-Locked appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from Locked to Unlocked ~unit will beep. Press the > repeatedly, until Chemistry Config. Wizard appears on the display.
How can I get my contol control panel unlocked?
Listen for a double beep and observe the “Control Lock” status light is lit when the control lock is in effect. Press and hold for 3 seconds the “Control Lock/Unlock” button on the control panel to unlock the control panel.
When does the control lock status light go out?
Listen for a double beep and observe the “Control Lock” status light is lit when the control lock is in effect. Press and hold for 3 seconds the “Control Lock/Unlock” button on the control panel to unlock the control panel. The “Control Lock” status light is goes out when the control panel is unlocked.
How to unlock the control panel on a Frigidaire Gallery refrigerator?
How do you unlock the control panel on a Frigidaire Gallery refrigerator? Examine the control panel and locate the ” Control Lock ” button, sometimes located next to the “Light On-Off” button. Press and hold the ” Control Lock ” button for a few seconds until the small red LED goes out.
Press the Menu until, Configuration Menu-Locked appears. To unlock, press and hold the (<) & (>) until the text, on the display, changes from Locked to Unlocked \~unit will beep\. Press the > repeatedly, until Chemistry Config. Wizard appears on the display.
What should I do if my Hayward pool is not working?
This means there has been a disruption in the transfer of information from the main PCB to the display (s). Deactivate all the breakers in the bottom of the control box and wait 5-10 seconds, then re-supply power to the control and check the display. If the problem has gone away the issue should have been cleared.
How to reset the Goldline / Hayward SWG panel?
To reset these light just push the black selector button in for 3 to 5 seconds and this will reset the trouble lights. After about an hour my readings were… Average 3200 and instant 3400 which is more in line with my tests. This also removes all past salt averages that may be in memory.
Do you need to change channels on Hayward pool?
You would need to change channels under the settings menu, 5 channels are available, you will need to re-teach all wireless units when the channel is changed. If changing channels does not solve the issue, the base receiver may need to be relocated closer to where the wireless unit will be used most often.
