How do I test my hot tub electric?

How do I test my hot tub electric?

Testing Heater Elements

1. Shut off all power to the spa at the breaker and spa pack.
2. Remove the wires or copper tabs on the heater element terminals.
3. Set your Ohm meter to the lowest setting.
4. Place your meter leads on the tip of each element terminal.
5. A reading of 10-14 Ohms is good for most heater elements.

Why is my Sundance spa not flashing FL1?

If this does not correct the flashing FL1 msg you could have a blockage in the circulation line or at the flow or psi switch or you could have a bad connection at the flow or psi switch or a bad flow or psi switch. If all else fails contact our Service Support Desk to book a diagnostic and repair of your Sundance Spa.

When to use Spa when temperature is flashing?

Do not use spa when temperature is flashing or the OH message is displayed. HLoH = Hi Limit Over Heat. Hi limit sensor is disconnected or shorted or the spa temperature is above 112° F. SEoP = Sensor open or disconnected. Heater disabled but the spa is operational. SESH = Sensor short, nonfunctional.

Which is Sweetwater Spa offers the best hot tub?

Sweetwater Spas constantly strives to offer the finest hot tub available, therefore modifications and enhancements may be made which affect the specifications, illustrations and/or instructions contained herein. FCC Notice

Why does my Sundance spa go into Oh error code?

Another issue that comes up and is an indication of a bad temp sensor is the temperature reading becomes inaccurate or the spa is going into the OH error code. If you power the spa down and power it back up it may work for a while but will do the same thing again. You need to replace the Temp Sensor. 3. FLO or OH Error Code

How to troubleshoot a flashing Flo for a spa?

First verify your spa is receiving the specified incoming voltage into the circuit board as well as out of the circuit board to the transformer. Also, check all fuses for continuity. Next, check the service tag on the side of your circulation pump. This will tell you approximately what voltage your circulation pump should be getting.

How can I tell if my Sundance Spa is having problems?

The only way to test this is to make sure there is no loose debris in the spa, then pull the filter out and see if the flow error goes away, if it does, it is the filter. 2. Defective Circ Pump or Flow Switch: Need to check for Circ Pump operation. Is there voltage going to pump, Is there adequate Flow coming out of Heater Port in Spa?

What does it mean when spa light is blinking?

SnA = Spa is shut down. Sensor plugged into jack A is not working. Snb = Spa is shut down. Sensor plugged into jack B is not working. SnS = Sensors out of balance. If alternating with temp, may be temporary condition. If display shows only this message (blinking) spa is shut down.

What does open sensor on spa water mean?

Open sensor (heater is deactivated) or Shorted sensor (spa is deactivated). Open or shorted sensor ( heater disabled). Overheat Protection (Heater is deactivated, pumps low speed is activated). Spa water is more than 20° F cooler than the temperature set point.