How do I SYNC my pentair easy touch Remote?

How do I SYNC my pentair easy touch Remote?

New member

1. press menu.
2. press down button, scroll to settings.
3. Press right button to select.
4. Press up button, scroll to “Wireless Address”
5. Press right button to select.
6. Now repeat steps 1-5 with the handheld wireless controller, “Address Found” will display.

How do I get my Iaqualink out of service mode?

Go to your outside control panel and on the left side of the panel there is a button next to colum showing Auto, Service, Timout. Hit the button twice to put it back in Auto.

How do I factory reset my IntelliFlo?

IntelliFlo Variable Speed Pump Factory Resetting

1. Make sure that the pump is on.
2. Press the stop button – the pump will stop.
3. Press and hold the four buttons simultaneously for about 4 seconds. Power off the unit and restart.
4. The factory settings will be in assigned.

Are there any problems with the Pentair easytouch remote?

I have a Pentair EasyTouch system with an 8 channel wireless remote. For almost 3 years now the remote has worked great. Never had any troubles with it. Now for the last 6 months or so, I’m having serious connection troubles. 99% of the time now the remote will just say “No Comm”.

Why does my Pentair pool remote say no Comm?

99% of the time now the remote will just say “No Comm”. While saying “No Comm” it’ll periodically cycle with “sync”. If I keep hitting the power button, eventually after a couple of minutes I’ll achieve sync and give me the normal display with the pool temp and time (which will be correct).

Where are the S1 switches on Pentair easytouch 8?

Flip all 10 of the the “S1” switches (located on the right side of the receiver) to “ON” using the sharp thin object on the receiver. Turn your remote control over and flip all 10 of its switches to “ON” as well. Your remote will now control all of the receiver functions.

What does the plate on a Pentair easytouch look like?

The receiver plate is the mounted device that looks like a small circuit board, which receives remote control signals and translates them to the LX Control Center. Use a small tipped object (such as an unfolded paper clip) to move the switches of the receiver.