How do I shut the water off to my boiler?
If you have a combi boiler then the hot water is supplied direct, so by closing the mains stop valve it will shut off the water. However, if you have a hot water cylinder this will be an indirect supply and there will be a valve on the pipe from the cold water storage cistern to the hot water cylinder.
Where is the shut off valve on a hot water heater?
Turning the Water off at the Water Heater When a hot water pipe is leaking, or if you need to repair or replace a water heater, there are shut-off valves located near your water heater. A water heater has two shut-off valves. A cold water inlet valve (often identified by a blue handle) feeds cold water from the main supply into the water heater.
Where are the shut off valves on a kitchen sink?
For sink faucets, look for the shutoff valves located below the sink, near where the water supply tubes run up to the tailpieces on the faucet. Any faucet that supplies both hot and cold water will have two valves—one for the hot water supply and one for the cold.
Where do you find a straight shut off valve?
Straight shut off valves are oriented so that the inlet and outlet of the valve are aligned and pointing in the same direction. You will typically find straight shut off valves on long sections of water pipes and where water lines come up through the floor to supply water to a plumbing fixture.
Where is the valve to turn off the water?
Any fixture or appliance should be equipped with some local shut-off valves. But if you don’t find the shut-off valves, don’t worry. You can shut off the water by turning off the main water supply valve near the water meter. That location is described below.
Turning the Water off at the Water Heater When a hot water pipe is leaking, or if you need to repair or replace a water heater, there are shut-off valves located near your water heater. A water heater has two shut-off valves. A cold water inlet valve (often identified by a blue handle) feeds cold water from the main supply into the water heater.
For sink faucets, look for the shutoff valves located below the sink, near where the water supply tubes run up to the tailpieces on the faucet. Any faucet that supplies both hot and cold water will have two valves—one for the hot water supply and one for the cold.
How does a water shutoff valve work on a refrigerator?
These are normally used to connect a water supply tube to a refrigerator, water filter, or other appliance. They work by clamping onto a water pipe and then forcing a hollow needle into the pipe to tap the water. A flexible copper or plastic supply tube is connected to the fitting on the valve to bring water to the appliance.
Any fixture or appliance should be equipped with some local shut-off valves. But if you don’t find the shut-off valves, don’t worry. You can shut off the water by turning off the main water supply valve near the water meter. That location is described below.
