How do I reset my warm tile thermostat?
To reset the Warm Tiles thermostat to factory default settings, turn off the circuit breaker in the electrical panel that supplies the Warm Tiles installation. Leave the circuit breaker off for 20 to 30 minutes. This will restore the Warm Tiles thermostat to the factory default settings.
How do you test a Nuheat thermostat?
There is no power going to thermostat. Press the GFCI test button at the top of the thermostat. If the red light at the top of the thermostat (or on the right side depending on the thermostat model) turns on, this indicates that there is power to the thermostat.
How to troubleshoot a Suntouch thermostat control panel?
Check the circuit breaker and try resetting the breaker. Measure the “Line side” voltage coming from the breaker panel at the control and test from “L1” to “L2.” Check all connections between the breaker and the control. Test the voltage at each connection starting at the breaker panel and proceeding toward the control.
Can a J2534 reprogrammer be used in a shop?
J2534 reprogramming is becoming an essential shop tool. Studies indicate that 7 out of 10 vehicles on the road require a calibration update. With a J2534 reprogrammer in your shop you can: Fix cars with the problems listed above.
Is it possible to reprogram a remote control?
Like any other electronic device, these key fobs can malfunction after some time, typically due to signal loss. However, in such a case, you can easily reprogram the remote yourself so you can still use it.
What does it mean to reprogram a car controller?
Reprogramming is the process of replacing the existing software in a vehicle controller with new software by electronically transferring approved calibration files from a vehicle manufacturer’s website. (Also known as reflashing, flashing, programming or reconfiguring.)
Check the circuit breaker and try resetting the breaker. Measure the “Line side” voltage coming from the breaker panel at the control and test from “L1” to “L2.” Check all connections between the breaker and the control. Test the voltage at each connection starting at the breaker panel and proceeding toward the control.
What kind of warranty do you get with Suntouch?
SunTouch will carry a one- to three-year limited warranty based on the SunStat model purchased. The SunTouch warranty is transferable to a new homeowner, unlike those from most other radiant heating companies. SunTouch warranties apply to the product, not just the original homeowner.
What should I do if my Suntouch panel is outside the range?
If your panel’s reading is outside the range on the nameplate label, call the manufacturer. Test the ohmmeter itself. Verify your meter is still working and properly calibrated by putting the two leads directly together to test the meter’s “zero reading”, often reading about 0.1 to 0.4 ohms.
How to adjust the floor temperature on Suntouch?
Use the up (or down) arrow to adjust the Floor Limit temperature to the desired floor temperature limit. If two floor temperature sensors are wired together in parallel to the control, it will give the control an artificially high floor temperature indication.
