How do I reset my truma water heater?
Make sure you remove your 240-volt connection if plugged into mains!
- Locate the long brown button.
- Push it in and hold it down until you see an orange LED light up.
- Remove your finger the replace the cover.
- Please note: You may need to repeat the process up to 3 times.
How do I reset my truma Combi 4?
How do I reset my truma combi? To reset the overheating protection, allow heater to cool, re- move connection cover and press red reset button.
Why is my water not getting hot in caravan?
Check for gas or electrical supply issues. More often than not, hot water systems stop working because of a fault in the gas or power supply. Check your other electrical appliances to ensure that they’re working. Check for a blown fuse, and replace if necessary.
How does truma heating work?
The appliance reduces the heat output before the desired heating and water temperatures are reached. When the set temperature is reached, the burner switches off. When the temperature falls below the set heater and water temperatures, the Truma Combi switches on again automatically to heat air and water (winter mode).
How do you fill a truma water heater?
Open the hot water tap in the bathroom or kitchen, set premixers or mixer taps to “warm”. Switch on the power to the water pump (main switch or pump switch). Leave the fittings open until the Truma electric boiler has been filled by displacing the air and water is flowing.
How does the truma Combi work?
What is the fault code for a Truma Combi?
Fault code 603 is………… Fault No.: 0603 Flashing code: ls slsl lsll Fault description: – Electronics blocked: – Because air temperature switch and / or water temperature switch has opened during operation due to overheating – Because combustion air temperature sensor signals temperatures > 215 �C 1.
What was the flashing light on my Truma Combi?
I went to air my van yesterday by turning on the blow heating, the control was set for gas only no hot water, after about 15 minutes the warning light was flashing red, I immediately turned off the heating and turned it back on 30 minutes later all ok for about 10 minutes again red light came on.
What does the trauma error code e507h mean?
On inspecting the truma console the error code E507H was showing. An investigation on the internet showed that this meant the gas bottle had emptied. I used the hob to boil some water and sure enough, after a minute the gas fizzled out.
Why is the fault 507, 516 or 517 appearing in Truma?
This was possibly caused by the heater control panel being switched off or because the heater’s 12-Volt supply was interrupted. The heater is also blocked for 15 minutes if the displayed fault is deleted four times without the gas supply being restored.
What are the fault codes on Truma Combi?
These were reported to the dealer, who looked at the problem twice, but failed to remedy the problem. I even sought help from CT members, with resets power downs etc. The fault codes usually initiated when trying to operate the heating or water heater on timer start.
On inspecting the truma console the error code E507H was showing. An investigation on the internet showed that this meant the gas bottle had emptied. I used the hob to boil some water and sure enough, after a minute the gas fizzled out.
This was possibly caused by the heater control panel being switched off or because the heater’s 12-Volt supply was interrupted. The heater is also blocked for 15 minutes if the displayed fault is deleted four times without the gas supply being restored.
What is the fault code on a Truma water heater?
The fault codes usually initiated when trying to operate the heating or water heater on timer start. We would always get either E 255 H – Defective control panel cable. or a error code that is not listed in the manual, which according to Truma CS is a purge fan failure.
