How do I reset my spa?

How do I reset my spa?

How to Reset a Spa Heater

1. Locate the spa’s high-limit reset. This is a red button found on many spa packs.
2. Press the high-limit reset button.
3. Turn on your spa and observe its operation.
4. Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.

How do I reset my Monarch spa?

Hear this out loudPauseBefore each use of the spa and with the unit operating, push the TEST button on each breaker. The switch should click over to the “Trip” position. Wait 30 seconds and reset each GFCI breaker by switching it completely off and then completely on. The switch should then stay on.

Are Monarch Spas good?

Hear this out loudPauseMonarch Spas were a good quality spa. They are no longer manufactured. Spare parts & repairs can still be carried out. If you’re looking for parts, Send us a photo to [email protected] and we, and we can identify it for you.

What to do if your spa unit has er-3 error message?

Heater has been active and has had insufficient water flow over the element. Low or no water flow has caused the heater temperature to exceed its maximum limits and the spa control has shut down operation to prevent any damage to the heater unit Turn mains power OFF and wait 10-15 minutes for element to cool and thermal cut-out device to reset.

What does an error message on a spa control mean?

The XS-2000 / 3000 / 4000 Series spa controls feature self diagnostics and scrolling error messages to quickly troubleshoot possible problems. Experiencing an error condition does not mean that your product is faulty. In fact most of the error conditions exist as a safety measure and to keep the spa control within its operating specifications.

What happens if you turn off spa pump?

Do not allow the spa filtration pump to continue to run after five (5) x failed priming attempts. Operating a spa pump without water for extended periods may cause damage to the pump. Turns power off, wait ten (10) minutes and then try again later. The in-heater water sensor constantly monitors the presence of water in the heater tube.

How to troubleshoot an internal controller fault in Spa?

Internal controller fault detected Hardware or software failure 1) Turn mains power OFF => wait 10 seconds => turn mains power ON 2) If error persists – contact your local spa reseller OR any SpaNETAuthorised Service Agent. (water & temperature) leave disconnected TM © SpaNET 2008.

The XS-2000 / 3000 / 4000 Series spa controls feature self diagnostics and scrolling error messages to quickly troubleshoot possible problems. Experiencing an error condition does not mean that your product is faulty. In fact most of the error conditions exist as a safety measure and to keep the spa control within its operating specifications.

Internal controller fault detected Hardware or software failure 1) Turn mains power OFF => wait 10 seconds => turn mains power ON 2) If error persists – contact your local spa reseller OR any SpaNETAuthorised Service Agent. (water & temperature) leave disconnected TM © SpaNET 2008.

How to troubleshoot the xs-2000 Spa store?

1. Turn mains power OFF and wait approximately 20-30 minutes for element to cool and thermal cut-out device to reset. Then turn power back ON 2. Check spa water level (refill if necessary) 3. Remove filters and clean by soaking in hot water and filter degreasing solution

What to do if water leaks into your spa?

Inspect under spa cabinet for evidence of water leaking onto spa control. If water present, turn mains power OFF and isolate, then resolve leak, dry up excess water, and allow spa control to dry out before restoring power. for assistance.