How do I reset my salt reading?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

When do I reset the average salt level?

How to Reset Average Salt Levels. The Average Salt level needs to be reset for start up, when a board is replaced, when major adjustments are made to the pool water, and when a cell is replaced. Note: new boards will display a factory default of 2800ppm. Step 1: To reset, move the switch to ‘Off’ and then back to ‘Auto’.

What to do if your salt level is above 3200ppm?

If salt level is above the range, partially drain the pool and/or spa and refill with fresh water to achieve a salt level of 3200ppm, refer to page 9, Step D. If the salt level is not high, verify the correct cell is being used then reset (follow steps for How to Reset Average Salt Levels above)

How to troubleshoot problems with your salt cell?

Starting with the average salt reading. Turn the switch to ‘Off’, then back to ‘Auto’. Wait for the relay to click (about 5 to 10 seconds). Press the ‘Diagnostics’ button 5 times, this will bring up the instant salt reading.

When to turn on high salt on Aqua Trol?

The ‘High Salt’ LED will be ON when the cell amperage is above the maximum limit. The ‘High Salt’ LED may also be ON if the wrong Turbo Cell is being used. The Aqua Trol systems are designed to only work with the t-5 model. The LCD display will read ‘HI’ when the amperage is above 6.40.

What causes instant salt reading to be zero?

There are two cases where the instant salt reading will be zero. The first is if the cell is not currently active it will show an instant salt reading of zero. You appear to have done the correct things to check for that, turning up to 100% and insuring that the water is above 60 degrees should allow the cell to always be on.

What should instant salt reading be on Hayward Omnilogic?

I have Hayward omnilogic which doesn’t have low salt light, However in diagnostics the instant salt reading is 0. My guess is the actual number is prob around 2000ppm based on last year’s number and what I drained and refilled. Will get it checked by the pool store too but having a reading of 0 concerns me.