How do I reset my Pentair variable speed pump?

IntelliFlo Variable Speed Pump Factory Resetting

Make sure that the pump is on.
Press the stop button – the pump will stop.
Press and hold the four buttons simultaneously for about 4 seconds. Power off the unit and restart.
The factory settings will be in assigned.

How do I fix error code 0021 on Pentair?

Communication Link between the HMI and Motor control has been lost: Check the jacketed wire on the back side of the keypad inside the drive top cover. Ensure that the 5 pin connector is properly plugged into the socket and that there is no damage to the cable. Maybe contact Pentair to see if they have any idea.

How do I reset my Pentair superflo?

To perform a Factory Reset:

Stop the pump if necessary by pressing the. Start/Stop button.
Record all of the custom schedule settings using. Table 3.
Press and hold the “1”, “2”, “3”, and “Quick. Clean” buttons for 3 seconds.
The screen will display “ ” if factory.
Be sure to reprogram the schedule and priming.

How many hours should I run my variable speed pool pump?

Variable-Speed Pumps: Variable-speed filter pumps should run longer, based upon the operating speed. Most pool owners run their variable-speed pump 12 hours per day (3-4 hours on high speed for the pool cleaning system and 8-9 hours on low speed for filtration).

Should I run my pool pump at night or during the day?

It may be cheaper to run the pump at night, but honestly you should run it 1 hour a day per 10 degrees of temperature at least, and it should be during the day. Running the pump at night should only be when you are doing a major chemical treatment such as algae clean-up.

What are the error codes on the Pentair pump?

Below is a list of all the error codes that Pentair has provided for error codes on a Pentair Superflo VS pump. These codes are a great way to do a simple diagnostic to see what issues your pump is having.

What to do if your Pentair speed pump stops running?

The info below is from the Superflo manual.. You can try it, and it certainly can’t hurt. Speed Pump will stop running. Disconnect power to the pump and wait until the keypad LEDs have all turned

Why is my Pentair Superflo vs not working?

An error occurred while retrieving sharing information. Please try again later. If you see that your SuperFlo VS is not running as scheduled, flip open the top and see if there is an error code of some kind. The screen will display an error code as Err and then display a number.

Why does my Pentair pool say err 000f?

I have a pentair variable speed and i went to set up spring schedule for the pump and the screen says err 000f cant do anything on the pump and dont want the pool turning on me any ideas as to what this is and how to fix it Welcome to TFP… A Great resource for all your pool questions…

The info below is from the Superflo manual.. You can try it, and it certainly can’t hurt. Speed Pump will stop running. Disconnect power to the pump and wait until the keypad LEDs have all turned