How do I reset my Pentair SuperFlo?

How do I reset my Pentair SuperFlo?

To perform a Factory Reset:

1. Stop the pump if necessary by pressing the. Start/Stop button.
2. Record all of the custom schedule settings using. Table 3.
3. Press and hold the “1”, “2”, “3”, and “Quick. Clean” buttons for 3 seconds.
4. The screen will display “ ” if factory.
5. Be sure to reprogram the schedule and priming.

How do you prime Pentair vs SuperFlo?

How To Prime Your Pentair Pool Pump

1. Turn off power to pump (switch and breaker)
2. Using black 3 way valve, turn off Skimmer (main drain on only)
3. Remove pump lid.
4. Fill pump with water all the way to top.
5. Put pump lid back on.
6. Turn on Pump.

Is the Pentair Superflo vs pump still working?

We have a Pentair Superflo VS pump that was installed 6 weeks ago and had been working flawlessly since installation. Yesterday, however, we discovered a problem.

What should I do if my Pentair pump is not working?

Press the Start/Stop button on the drive keypad. If the pump is currently scheduled to run it will start. start the pump. remove any blockage. Look under troubleshooting for errors and alarms. Hello All: I have the solution! I called Pentair customer service on Monday morning.

Why is my Pentair pool skimmer not working?

In the morning our pool water level was low, so when I heard gargling in the skimmer at the programmed start time of the pump, I walked over to the pump, pressed the Start/Stop button to shut it off, and also turned off a wall switch I have for the pump so that someone else wouldn’t start it later. After work I filled the pool.

Why is the control panel on my Pentair not working?

Besides the Power LED Indicator, none of the other Control Panel buttons are responsive. I reset the circuit breaker last night, but the same happened: Power LED is on, nothing else works. I left the power to the pump on all night hoping that it might resolve itself, but it didn’t.

Why is my Pentair Superflo vs not primed?

If you see that your SuperFlo VS is not running as scheduled, flip open the top and see if there is an error code of some kind. The screen will display an error code as Err and then display a number. The most common one is the Err 0002 and it is usually caused by the impeller getting clogged and the pump is unable to prime.

How do you fix a Pentair Superflo water pump?

Once the impeller spins freely the blockage has been cleared. Fill the pump up with water and put the lid back on. The second method is to use a ¼” Allen Wrench and insert it into the back of the pump. Gently turn it back in forth until the impeller begins to spin freely again. It may take a bit of effort.

Is the Pentair vs pool pump still sold?

I do not believe Pentair sells the VS motor on its own. You can put a VGreen 1.65hp VS motor on the pump. Or switch to single speed and next time it needs to be replaced then switch back to VS as single speed pool pump motors over 1.1THP will no longer be sold as of July 2021. InyoPools carries a complete range of motors for pool pumps.

How old is a Pentair Superflo pool skimmer?

I’ve got a Pentair 342001 SuperFlo VS, maybe 2 years old, and it was running. I hit the stop button to to clean the skimmer, and then turned it back on or tried to. It wouldn’t turn back on.