How do I reset my Pentair ScreenLogic interface protocol adapter?
Also, how do I reset my Pentair protocol adapter? You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. You canunplug and plug back in the wireless router to reset it.
Do you need a Pentair screenlogic 2 adapter?
This is a replacement Pentair’s ScreenLogic2 allows you to control the IntelliTouch or EasyTouch System right at your fingertips. You would need to purchase item #520500 to convert to ScreenLogic Wireless Interface for computer and mobile devices. So I tried pentair’s “high gain” antenna 520639 – that did nothing – still a real flaky connection.
How to troubleshoot Pentair screenlogic pool pool problems?
1 Make sure your wireless ScreenLogic2 device is connected to your wireless router. 2 Locate your ScreenLogic2 Protocol Adapter and wireless router. Verify the wireless router Power LEDin on. 3 Verify the wiring to the protocol adapter and IntelliTouch Load Center.
How does the screenlogic2 interface work in a pool?
The ScreenLogic2 Interface allows you to control the key functions of a pool or spa using the IntelliTouch® and EasyTouch® control systems, through controllers such as an iPad®, iPhone®, iPod touch® mobile digital device, and Mac® computers. All ScreenLogic2 kits come with a protocol adapter and ScreenLogic2 Interface PC program on CD.
Is there a wireless adapter for screenlogic?
I tried it with the wireless interface (my kit looks like this: Pentair Screenlogic Interface & Wireless Connection Kit for EasyTouch & IntelliTouch Control Systems | 522104 ).
Are there any problems with Pentair screenlogic 2?
Problems with Pentair Screenlogic 1. Make sure your wireless ScreenLogic2 device is connected to your wireless router. In most cases, theeasiest way to… 2. Locate your ScreenLogic2 Protocol Adapter and wireless router. Verify the wireless router Power LEDin on. These two… 3. Verify the wiring to
How do I reset Pentair screenlogic wireless router?
Cycle the power to both of these devices.You can use a paper clip to reset the Protocol Adapter by pressing the recessed reset button. You canunplug and plug back in the wireless router to reset it. 3. Verify the wiring to the protocol adapter and IntelliTouch Load Center.
Where do I hook up my screenlogic interface?
Note: The above ScreenLogic Interface Kits (520500 and 520502) require a four-wire, 22-gauge wiring connection from the IntelliTouch or EasyTouch Controller Load Center COM port to the protocol adapter within the home.
I tried it with the wireless interface (my kit looks like this: Pentair Screenlogic Interface & Wireless Connection Kit for EasyTouch & IntelliTouch Control Systems | 522104 ).
