How do I reset my Pentair pump?

Simply follow these steps to factory reset your unit:

Make sure that the pump is on.
Press the stop button – the pump will stop.
Press and hold the four buttons simultaneously for about 4 seconds. Power off the unit and restart.
The factory settings will be in assigned.

Where is the reset button on a Pentair pool pump?

there is no reset button, that you can manually press to reset it. There is an internal “thermal overload switch”, which is an automatic reset. So if your pump motor is overheating, it will turn off, but once it cools down enough, it will reset automatically.

How do you restart a pool pump after a power outage?

Close any drain plugs or valves you may have opened during the power outage. Turn the breakers back on and prime the pool pump by adding water to the pot, replace the lid and turn the pool pump on. Ensure your pool pump and filter are working, and then let them run for one hour to begin decontamination.

Why is my Pentair pool pump not working?

After work I filled the pool. When I went back to start the pump, I first turned on the wall switch and noticed that the Power LED Indicator on the Control Panel turned on. I then pressed the Start/Stop Button, but nothing happened. Besides the Power LED Indicator, none of the other Control Panel buttons are responsive.

Why is the control panel on my Pentair not working?

Besides the Power LED Indicator, none of the other Control Panel buttons are responsive. I reset the circuit breaker last night, but the same happened: Power LED is on, nothing else works. I left the power to the pump on all night hoping that it might resolve itself, but it didn’t.

Why does my Pentair pump go into safe mode?

A drive (ie pump) may enter safe mode for a number of reasons like an electrical surge, running dry, etc. It’s a safety mechanism to protect the motor. Frustratingly, this is not in the manual!! I asked why and they said they’ll likely put it into an updated version.

Is the Pentair Superflo vs pump still working?

We have a Pentair Superflo VS pump that was installed 6 weeks ago and had been working flawlessly since installation. Yesterday, however, we discovered a problem.

What should voltage be on Pentair pool heat pump?

Check supply voltage to the heat pump. Supply voltage should be between 208 and 260 volts. Check to see if a phase is out. Should have 120 volts to ground and 240 volts across power legs. HIGH REFRIG Alarm: Refrigerant high pressure switch is open.