How do I reset my Maytronics dolphin?
With your Dolphin in use, press the “Reset” button. Hold the “Reset” button down for about 3-5 seconds. Check the Full Filter Light indicator, ensuring that it’s off. In essence, what you’ve just done is “zero” out the sensor.
Why does my dolphin stop?
If your Dolphin moves a few feet but then stops, it could be there’s a drive train or impeller blockage to blame so have a closer look: Inspect the impeller itself. Inspect all tracks and brushes. Remove any debris that’s visible.
Is there a problem with the Dolphin S200?
Symptom as below: Turn on power, S200 moves forward for 3-5 feed, then backward for 1 foot, then stops moving completely. Turn off power then turn on power, same behavior repeats. – rotating forward for 10+ seconds. Seems self test on ground works fine.
Why is my dolphin pool cleaner not working?
The light may be on in the control unit but it may not be putting power out from the plug area that the dolphin plugs into. As well as the motor in the dolphin head could be bad. Most often it is the control box. Ask Your Own Pool and Spa Question
Is there any way to troubleshoot a dolphin?
Dolphin Troubleshooting is simple. Don’t even bother taking apart the motor compartment. Besides having many many screws, you just can’t get replacement parts so save your time. Help has arrived!
What should I do if my Maytronics dolphin stops working?
Prevention is the best remedy. Avoid operating your Maytronics cleaner under any conditions that will clog the bag and prevent water circulation around the motor housing. Heat will destroy the electrical components inside the case. Re-coil the cable after every use starting at the robot and working the twists outward to the plug.
The light may be on in the control unit but it may not be putting power out from the plug area that the dolphin plugs into. As well as the motor in the dolphin head could be bad. Most often it is the control box. Ask Your Own Pool and Spa Question
Dolphin Troubleshooting is simple. Don’t even bother taking apart the motor compartment. Besides having many many screws, you just can’t get replacement parts so save your time. Help has arrived!
Prevention is the best remedy. Avoid operating your Maytronics cleaner under any conditions that will clog the bag and prevent water circulation around the motor housing. Heat will destroy the electrical components inside the case. Re-coil the cable after every use starting at the robot and working the twists outward to the plug.
Which is better to leave the robot dolphin in the chlorine pool?
Which is better or worse to leave the robot it in the chlorine pool where it can dry out because of chemical or leave it out of the pool in the hot sun … will not go in reverse My Dolphin is about 12 years old. It will go until it needs to reverse then it stops. HELP PLEASE. Dirt bypassing filter
