How do I reset my LM3?

The output button is used to set the chlorine output of the Zodiac LM3. Chlorine output is selected by repeatedly pushing this button until maximum is reached on the chlorine output indicator. An extra push of this button will reset the output to minimum.

How do you reset a Zodiac TRi chlorinator?

– If TRi electrode has been replaced, press the ‘Select’ switch to reset cell operating hours. – If not (just for a normal control), press the ‘Menu’ switch to come back to default LCD display. (all memories and setting are consequently reset to zero).

How do you reset the sign EI 25 chlorinator?

The pump protection timer can be manually reset by pressing button twice. Turn the chlorinator ‘ON’ by pressing the button. Press the UP button to reach the desired output level.

How do you clean a Zodiac salt water chlorinator?

Here are ten easy steps to clean your cell:

Switch off the filter pump and chlorinator and close the necessary valves.
Unplug the cell terminal cap.
Unscrew the electrode retaining ring and remove the electrode.
Immerse the electrode in self-cleaning solution ensuring that the terminals are not immersed.

What setting should my chlorinator be on?

We suggest you start your salt chlorine generator at 50 percent output and run it for a couple of days, then check the chlorine level. In a balanced pool, a good chlorine level is 1-3 parts per million. If your chlorine levels are low, you can raise the percentage, and if it’s high you can lower the percentage.

Is the zodiac LM3 a salt water chlorinator?

Breakthrough salt water technology. Zodiac has expanded the horizon of pool water treatment to bring you the ultimate salt water chlorinator: LM3 is state-of-the-art cell that maximises the efficient sanitation of your pool water. The Zodiac LM3 salt water chlorinator allows you to set and forget your level of chlorine output.

What should I do before turning off my LM3?

• Power to the LM3 should be turned off before unplugging the cell connectors to prevent cell damage and low voltage sparks. • Keep the cell terminals protected with a light coating of silicone grease to allow for a positive electric connection. Use of any other type of grease may damage the terminal seals and o-rings.

What to do if your LM2 pump is not working?

With power off at the source, locate circuit breaker on bottom of unit near power cord. Push button in and turn on power. If power to transformer is not restored, replace circuit breaker. My LM2 or LM3 will not operate. After verifying that the pump is on and the unit is turned on, inspect for proper function.

How long does a salt chlorinator Control Board last?

If the salt system is still within the warranty period, by all means, get on the phone with the manufacturer’s support reps, for some advanced troubleshooting, or warranty service. Most salt cells last 3-5 years, depending on the salt system, and situational factors. The control boards used can last 3x as long,…

How does the LM3 series chlorinator work?

Note: The LM3 Series uses a smart switch that turns the chlorinator on automatically with each pump cycle. If longer periods of zero (0) chlorine output are required, disconnect the yellow plug cap from the cell. (Red NO FLOW light will illuminate once chlorine production has stopped.) Plug cap must be reconnected for chlorine production to begin.

Is the zodiac LM3 salt water chlorinator backed by a warranty?

And don’t forget that your Zodiac LM3 Saltwater Chlorinator is backed by a comprehensive warranty. The exclusive Zodiac warranty is an expression of the confidence which Zodiac Group Australia has in its products, and is your re-assurance of prompt and expert after-sales service by professional technicians.