How do I reset my leisure Bay Spa?

DO NOT ENTER THE WATER. Remove the spa hot tub hard cover and allow water to cool off. Once the spa cools down to 107°F, the tub should reset on its own. If the hot tub does not reset, turn off the power to the spa and call your dealer or service company.

How do I turn on Leisure Bay spa?

Turn on power to spa at the circuit breaker box. The heater and pump 1 (low speed) will automatically activate. Depress JETS 1 topside pad on the control panel once to activate pump #1 in high speed and initiate maximum water flow to certain jets.

What to do if your spa heater does not heat?

Once they are removed, tape them together; turn the thermostat dial down to the off position, and turn the power back on. Make sure the spa is on the heater/filter cycle and water is flowing from the jets, turn the thermostat dial up while watching the contactor, if it closes when doing this, then re-test the heater using the amp-meter.

Why does my digital spa heater not reset?

A digital spa pack may not have a manual high-temperature reset switch. This is controlled by a sensor instead. If the heater element is not getting the proper amount of water flow due to pump problems or poor water level, the sensor will trip the heater and cause it to stop operating.

What does it mean when your hot tub is not heating?

In this case, your control panel topside may show LF or FLO (or a similar flow message). This means there is an issue with water flow, and not enough water is passing through the heater. As a safety feature, the heater should be designed to cut out so it doesn’t burn out.

Is there a reset button on a hot tub heater?

Make sure the spa water is at the proper fill level. Never try to operate a heater if the spa is not at its proper fill level. Doing so can cause the pump to lose prime and the heater element to burn up. A spa heater has a high-limit reset button. A spa or hot tub provides a form of personal relaxation known as hydrotherapy.

When do I need to reset my hot tub heater?

A spa heater has a high-limit reset button. A spa or hot tub provides a form of personal relaxation known as hydrotherapy. The spa’s pump and heater provide a soothing environment by circulating water through jets and increasing it to the bather’s desired temperature. A spa heater may need to be reset if it has tripped or stopped working.

Where is the high limit reset button on a spa heater?

This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple. Press the high-limit reset button. When this button is tripped, it will “click” in when you reset it. Turn on your spa and observe its operation.