How do I reset my LCI panel?

How do I reset my LCI panel?

Resetting Lippert Ground Control Leveling System After Dead…

1. In manual mode, run the jacks to level the trailer.
2. Once the trailer is level, turn off the touch pad.
3. With the touch pad off, press and release the “FRONT” button five (5) times and then press and release the “REAR” button five (5) times.

How to troubleshoot LCI leveling system troubleshooting panel?

Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time Front Jack Legs On Lippert Ground Control Lower When Slide Is Used Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module

How can I Reset my Lippert LCI leveling system?

My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink.

Why is the touch screen on my LCI not working?

Small red lights are on. None of the buttons work. Received new touch pad but no difference. The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue.

How can I check the fluid level on my LCI?

Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink. Trans fluid level is hard to check as it is transparent on the dip stick. But the see through fluid tank shows level is about an 1-1/4 in below top of tank.

Troubleshooting Panel of LCI Leveling System that Has Down Light that Stays on All the Time Front Jack Legs On Lippert Ground Control Lower When Slide Is Used Setting Up Lippert Ground Control 3.0 After Installing Replacement Control Module

My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink.

Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink. Trans fluid level is hard to check as it is transparent on the dip stick. But the see through fluid tank shows level is about an 1-1/4 in below top of tank.

Small red lights are on. None of the buttons work. Received new touch pad but no difference. The blank screen on your LCI Ground Control 3.0 could be either a power issue or a control module issue.