How do I reset my Jandy iAquaLink?
How do I Reset a Jandy AquaLink System?
- Press the “Menu” button.
- Scroll to and highlight “System Setup” using the arrow keys. Press “Enter.”
- Scroll to highlight “Clear Memory,” then press “Enter.” You have now reset your AquaLink system.
How do I change my iAquaLink WiFi?
Inside the iAquaLink 2.0, toggle the WiFi – Wired switch to clear the Wi-Fi settings and put the iAquaLink in desired setup mode. 3. After clearing the WiFi settings and with the Wired/ WiFi switch set to WiFi, use a smartphone or WiFi enabled device and go to WiFi settings.
Where is the iAquaLink device number?
Enter the iAquaLink device number found on the door hanger or the device itself. To add the iAquaLink device to an account, you must be connected to the web through the same router the iAquaLink device is connected to.
Is there a problem with iaqualink 2.0 connection?
Just had a brand new iAqualink 2.0 system installed and even got it connected to my wireless network (solid yellow and green lights).
What do I need to install iaqualink in my Pool?
iAquaLink installation consists of wiring the iAquaLink Web Connect Device to the RS485 communication port on an AquaLink automation system. This must be done by a licensed electrician or a qualified pool professional. The device is weatherproof so it can be mounted in the best position for connection to the modem/router.
Why is my iaqualink pump run times not working?
If you can ping it and have the correct SN they should be able to access it and get it setup. They were even able to tell me why one of my pump run times was not working by what they could see (there was a second page of setup menu I did not notice).
How do I connect iaqualink to power center board?
Guide the connector and wire through to the rear of the power center board. Pull the connector between the PC board & the metal brace, and connect it to the red 4-pin socket as shown. Up to two devices can be connected to one 4-pin socket (two wires per hole). If more capacity is needed, a 6584 multiplex board can be installed.
Just had a brand new iAqualink 2.0 system installed and even got it connected to my wireless network (solid yellow and green lights).
iAquaLink installation consists of wiring the iAquaLink Web Connect Device to the RS485 communication port on an AquaLink automation system. This must be done by a licensed electrician or a qualified pool professional. The device is weatherproof so it can be mounted in the best position for connection to the modem/router.
How tall does an iaqualink 2.0 antenna need to be?
Attach the iAquaLink 2.0 antenna as close to the home’s router as possible. 2. Locate the WiFi/Wired switch and ensure it is in the WiFi position 3. Mount the iAquaLink 2.0 antenna at least 6 ft. (2 m) high and 10 ft. (3 m) from any electric motor, device, or metal object.
How to install iaqualink for Zodiac Pool automation?
Zodiac automation installation consists of wiring the iAquaLink 2.0 antenna to the RS485 communication port on AquaLink TRi automation system. This must be done by a licensed electrician or a qualified pool professional. The device is weatherproof so it can be mounted in the best position for connection to the modem/router.
