How do I reset my Jandy AquaPure 1400?
Turn off the system and unplug the little board and then reinstall it. Turn on the system, wait for about 5 minutes, and then hold the little white button for 5 seconds. This will calibrate the sensor.
How do I calibrate my AquaLink?
How to calibrate the temperature on your iAqualink Unit
- Click on the “Pool” button.
- Adjust the temperature using the arrow keys.
- Click the “Back” button until you reach the home screen again.
What does code 170 on Jandy aquapure mean?
Generates code 170 IF 188 is not present. VAC input voltage too low. Relay not conducting in the forward direction. Relay not conducting in the reverse direction. High cell current (at upper limit of A/D converter) and cell voltage falls below 19V. High cell current and cell voltage falls below 19V.
What is the code for Jandy aquapure power supply?
1.They all generates code 172- Flow sensor service is required. 2. Perform diagnostic test on board to ensure the board isn’t faulty. If not the board, the tri-sensor is the culprit. 3. How To Change a Jandy AquaPure Tri-Sensor Front board power supply is either too low or too high. 1. Generates code 173- Low input voltage, IF code 188 is present.
Why is the salinity invalid on Jandy aquapure?
Cell current is 85% lower than desired and cell voltage above 19V. Salinity invalid due to out of range measurements caused by front board error. Although the charts should help narrow down the root to the issue on your Jandy AquaPure unit, it may not completely answer all your questions or concerns.
What to do if you get a Jandy error code?
1. Recalibrate salt reading. 2. Backwash your filter if a DE filter is installed. 3. Partially drain your pool and dilute with fresh water until salinity level returns to 3.0. 1. Typically caused by low AC voltage from back board. Check the transformer and back board.
Generates code 170 IF 188 is not present. VAC input voltage too low. Relay not conducting in the forward direction. Relay not conducting in the reverse direction. High cell current (at upper limit of A/D converter) and cell voltage falls below 19V. High cell current and cell voltage falls below 19V.
What is the power supply code on Jandy aquapure?
Front board power supply either too low or too high. (Generates 173 – Low input voltage code if Level 2 code 188 is present) (Generates 170 code if 188 is not present) Contact a pool professional. VAC input voltage is too low.
Where to get help with aquapure error codes?
If you need more help understanding the AquaPure Error Codes, or need help fixing the issue, stop by a local Leslie’s Pool Supplies store and speak with a trained pool professional today. You can also request pool equipment and repair services by contacting our Pool Service and Repair Department HERE.
Cell current is 85% lower than desired and cell voltage above 19V. Salinity invalid due to out of range measurements caused by front board error. Although the charts should help narrow down the root to the issue on your Jandy AquaPure unit, it may not completely answer all your questions or concerns.
