How do I reset my Intellichlor salt cell?
Press and hold the “More” button for 3 seconds to enter system status mode. All the lights will scroll across the panel, and then go dark. Only the “Power”, “Cell”, “Life”, and “Low” lights will be lit.
What temperature does a salt Cell stop working?
Your Salt System and Winter Temperatures For most Pentair Intellichlor systems, the setting is the water temperature dropping below 52 degrees. When the sensors note the water temperature dropping below that value, the system will effectively shut off and stop their Chlorine production.
What does the intellitouch say about the salt level?
IC60 is working fine, status lights are good for flow and salt level, water temp is high enough to produce chlorine, but your Intellitouch and ScreenLogic are showing 0ppm on the salt level? I was told there is a second sensor in the IC60 that sends info to the Intellitouch.
What does the flashing light on the intellichlor mean?
EasyTouch has capability to calibrate the water, air and solar sensors. The IntelliChlor self calibrates. If the salt good light is flashing green this does mean the salt level is very hi in the pool. This should be corrected quickly to prevent damage to pool equipment.
What is the percentage of chlorine produced by an intellichlor?
Victor if your IntelliChlor is a 2011 model or later the five LED indicators display as a bar graph to show the cell output in either 2% or 20% increments, the percentage of the total output capacity of chlorine being produced. Percentages from 2% to 10% are represented by blinking LED’s. Percentages from 20% to 100% are represented by solid LED’s.
Is the salt level on my Pentair cell zero?
All green lights on cell, but what’s being reported shows “0” salt on app. This is my 3rd cell in 4 years (same reason, every year) I spoke with tech support at Pentair. They said that they had changed mfg 5x last so many years because of “no salt” issues with these things.
Are there any changes to the Pentair intellichlor salt cell?
Pentair has made some significant design changes to the IntelliChlor Salt Cell. In my opinion they’ve simplified the front control panel although the verdict is out as to technical changes that have been released. I’ve been seeking a HOW TO calibrate the IntelliChlor and my sources at Pentair provided this Field Calibration Guide.
Can a Pentair intellichlor power center be used for ic20?
Yes, the Pentair IntelliChlor Power Center (p/n 520556) can be used for the IC20, IC40, & IC60P Salt Cells. Red Square Pools says: September 19, 2015 at 5:52 am
How can I tell the version of my intellichlor salt?
To determine the version of your IntelliChlor Salt Cell flip the cell over and look for the label stamped with a bar code. Look to the bottom left corner of that sticker to identify the version number (see picture). Chances are the sticker may have fallen off over the course of time. Here’s another trick I’ve found.
