How do I reset my Hayward salt system?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

What if my Hayward salt chlorinator reads high salt?

The High Salt LED will be ON when the cell amperage is above the maximum limit. High Salt LED may also be ON if the control is set for the wrong Turbo Cell type. The LCD display will read ‘HI’. Verify salt level is 2700-3400ppm and check with independent test to ensure accuracy.

What do you do when a Salt Cell says no flow?

The most common reason for low or no flow is that the baskets are full of debris. By checking and emptying both the skimmer basket (by the pool) and the pump basket (inside the pump) this will free up the water flow, allowing the system to fully ‘prime’ and function at full capacity.

Which way do you install a salt cell?

For most installations, we recommend installing the flow switch after (downstream) of the cell. The flow switch can be installed before or after the cell but there must be 12″ of straight pipe before the flow switch. The cell counts as 12″ of straight pipe if installed directly before the flow switch.

How to tell if a salt cell is working?

The easiest way to be certain if the chlorinator is working is to make sure the cell is clean by checking the needle or production lights on the chlorinator box. When operating, you should also see bubbles (hypochlorite gas) inside the chamber, producing what looks like cloudy water – that’s chlorine being created!

How to use the Hayward Aqua rite chlorine generator?

Hayward Aqua Rite – Chlorine Generator, Salt Cell Information. – YouTube If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later.

How to set Turbo cell size on Hayward Aqua rite?

How To Set Your Turbo Cell Size Slide your main switch to the AUTO position. Switch your cell type by cycling the main switch from AUTO to SUPER CHLORINATE and then back to AUTO. Push the diagnostic button until “T-XX” appears on the display.

How much does Hayward Goldline Aqua rite main PCB weigh?

This main PCB is designed to use with Hayward Goldline Aqua Rite salt chlorine generator model AQR. Weight 25 pounds. Would you like to tell us about a lower price? Pages with related products.

What should the salt level be in my Hayward pool?

Push the diagnostic button until “T-XX” appears on the display. Step 2: Verify the accuracy of the salt readings (2700-3400 pm) with an independent test kit or by taking a water sample to your local pool store for testing. 3200 ppm is the ideal level. If the salt level is below range, add enough salt to achieve a salt level of 3200 ppm.

Hayward Aqua Rite – Chlorine Generator, Salt Cell Information. – YouTube If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later.

How to replace Hayward GLX-DSP Aqua-rite PCB display?

Cut power from the chlorinator, unplug the white T cell cable, and remove the two screws that hold the cover in place. Remove the disply unit and plug in the new board. Make sure you don’t bend any of the contacts. Replace cover and screws, plug in the T cell cable, restore power, and you’re done. Total time to replace…less than 5 minutes.

This main PCB is designed to use with Hayward Goldline Aqua Rite salt chlorine generator model AQR. Weight 25 pounds. Would you like to tell us about a lower price? Pages with related products.