How do I reset my Hayward Pool?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How to troubleshoot Hayward pool OnCommand troubleshooting guide?
Remove the two screws and open the door to access the wire harness connecting the display panel to the integrated control board. Next, disconnect the harness from the display board and remove the door from the hinges. To remove the right side panel Remove the two screws and open the door. Next, slide the door towards the right to remove.
How to turn off auxiliary relay Hayward pool assets?
The auxiliary button that was programmed to function as “filter low speed” will now become inactive. The high and low speed are now toggled by pressing the filter button, first time=high, second time=low, third time=off. 2. Any auxiliary relay that is “Interlocked” will not activate unless the system is in Pool Mode
Why is my OnCommand not working in my Pool?
Any auxiliary relay that is “Interlocked” will not activate unless the system is in Pool Mode and the Filter Pump Relay has been activated for at least three (3) minutes. 3. Certain features or devices have to be configured in the system so that the OnCommand knows they exist, otherwise, they will not operate.
How to set the high and low speed on Hayward pool?
The high and low speed are now toggled by pressing the filter button, first time=high, second time=low, third time=off. 2. Any auxiliary relay that is “Interlocked” will not activate unless the system is in Pool Mode and the Filter Pump Relay has been activated for at least three (3) minutes. 3.
Do you still need Hayward pumps and filters?
We carry the other brands, but Hayward pumps and filters have always been our flagship line. Reliable & durable, Hayward pumps will still likely need some type of troubleshooting at some point during your relationship.
Remove the two screws and open the door to access the wire harness connecting the display panel to the integrated control board. Next, disconnect the harness from the display board and remove the door from the hinges. To remove the right side panel Remove the two screws and open the door. Next, slide the door towards the right to remove.
What are the operating rules for an OnCommand?
OnCommand’s operating rules. 1. If the Filter Pump is configured as a two-speed pump, the system will prevent the Low Speed Relay from activating at the same time as the filter pump relay. The auxiliary
