How do I reset my Hayward Pool controller?
If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
What do you need to know about Hayward Pro Logic?
2 Introduction The Hayward Pro Logic is a multifunction pool controller used to fully manage your pool/spa sys- tem. The Pro Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Pro Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control.
How many Hayward heaters can a Prologic system control?
• All ProLogic systems are salt chlorination ready and can control 4-16 high voltage relays, 3-4 valve actuators and 1-2 heaters. • These systems can manage: Hayward Variable Speed Pumps, ColorLogic Lighting, Sense & Dispense, AquaConnect Homenet, as well as a wide variety of remotes. • The panel features an 8 slot, 100amp subpanel.
How do I recalibrate my Hayward Pro Logic salt sensor?
With the pump running, take the power switch down to the “Off” position, and then back up to “Auto”. You should hear a click within 10 or 15 seconds. When you do, press the diagnostic button five times in a row. The system will go through a recalibration process. Wait until the numbers stop changing.
How to reset config on ProLogic Hayward pool?
To exit Config., press the Menu button, to continue programming press the (>) button. How To: Reset Config. to Default 7 Step 3 Step 4
How many Hayward pump actuators does ProLogic control?
ProLogic: How It Works • All ProLogic systems are salt chlorination ready and can control 4-16 high voltage relays, 3-4 valve actuators and 1-2 heaters. • These systems can manage: Hayward Variable Speed Pumps, ColorLogic Lighting, Sense & Dispense, AquaConnect Homenet, as well as a wide variety of remotes.
Why is the check system light off on Hayward Pro Logic?
When I go outside to the actual Pro Logic box, the check system light is off. Only the Aqua Pod is flashing “check system”. How do I figure out what the problem is? If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
How many relays are in a ProLogic pool?
Manage up to 16 pieces of equipment (4, 8 or 16 Relays), two heaters and a solar system on any pool, spa or pool/spa with shared or dual equipment. Automate up to 8 rotating valves (4 or 8 valves) to control system flow and to create unique water features.
