How do I reset my Hayward Aquarite?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

Why are the lights not flashing on my Aqua rite pool?

1. “Power” LED not on screw terminals at the Aqua Rite control. Verify input voltage with a voltmeter. If there is input power, the fuse may have blown. The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector. 2. “Generating” LED flashing

How to reset the inspect cell led on aquarite?

To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).

What are the polarities of the aquarite led?

Check Salt & Inspect Cell LED flashing or ON Check cell voltage and amperage in both polarities. step C Voltage Range: 22.0 — 26.0 VOC 8.0 amps 6.7 amps 5.7 amps 4.5 amps Super Chlorinate Auto Off Super Chlorinate Auto Off To switch polarities, cycle Main Switch from AUTO* OFF + AUTO.

When does the high salt light come on on aquarite?

High Salt LED ON The High Salt LED will be ON when the cell amperage is above the maximum limit. High Salt LED will also be ON if the control is set for the wrong Turbo Cell type. The LCD display will read “HI”. Verify salt level is 2700-3400ppm and check with independent test to ensure accuracy.

To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).

When to turn off LED light on Hayward Aqua rite?

Step 1: Wait 60 seconds after the pump starts. Typically, the LED light should shut off after 60 seconds. If it does not, keep reading. Step 2: Verify that you have enough straight pipe before where you have installed your flow switch. There should be at least 12″ of straight pipe before the switch.