How do I reset my Hayward Aqua plus salt cell?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus key once. This should reset the light and message.
What temperature does a Hayward salt Cell stop working?
In pool water temperatures that are 60 degrees or below, the salt generators simply shut down and by design do not allow the salt cell to ionize (breakdown) the salt and convert it to chlorine.
How to troubleshoot problems with your salt cell?
Starting with the average salt reading. Turn the switch to ‘Off’, then back to ‘Auto’. Wait for the relay to click (about 5 to 10 seconds). Press the ‘Diagnostics’ button 5 times, this will bring up the instant salt reading.
Why is the salt reading on my cell phone too high?
That is probably why the salt reading and the amps are too high. If you have a volt meter you could measure across the red and black wires that come from the rectifiers and see what the voltage reads there. If it is normal, then it is likely to be an issue on the board.
When to add salt to a salt cell?
If value is not reading within 500ppm of independent test, then replace cell. If number is reading within 500ppm of the independent test and the ‘Inspect Cell’ LED is flashing, add salt until level is above 2700ppm. The ‘High Salt’ LED will be ON when the cell amperage is above the maximum limit.
How to fix high salt reading on Hayward T-15 cell?
Take pictures of the wiring connections (label if necessary), disconnect all the wiring from the PCB. Carefully inspect/fix the PCB in a controlled environment for your own comfort. Having to flip the PCB over and over with all the wires tied up can often lead to another potential issue.
Starting with the average salt reading. Turn the switch to ‘Off’, then back to ‘Auto’. Wait for the relay to click (about 5 to 10 seconds). Press the ‘Diagnostics’ button 5 times, this will bring up the instant salt reading.
That is probably why the salt reading and the amps are too high. If you have a volt meter you could measure across the red and black wires that come from the rectifiers and see what the voltage reads there. If it is normal, then it is likely to be an issue on the board.
How to reset the salt level on a turbo cell?
You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus (+) key once. This should reset the light and message. Lastly, follow the instructions on page 16 to reset the salt level after cleaning the cell. Page 8 1.
When do salt and inspect cell LEDs flash?
Check Salt & Inspect Cell LED’s will be ON when salt level is 2300ppm or less. Chlorine production is halted. Inspect Cell LED will flash by itself when 500 operational hour countdown timer has expired. Requires manual reset.
