How do I reset my Balboa jacuzzi?

Canadian Spa Company

Step 1: Turn off the power to the Spa.
Step 2: Remove cabinet panel, and covering for the control system.
Step 3: Locate the heater’s sensor wires and trace them to where they plug into the circuit board (pictures below).
Step 4: Disconnect the sensor wires from the circuit board.

How long can you run hot tub jets?

Since your hot tub pump circulates the warm water as well as the sanitizer, a general rule is to follow manufacturer recommendations or leave the pump on for a minimum of eight hours per day.

How long does it take for hot tub jets to turn off?

For example, high speed jets typically turn off after 15 minutes of use, and low speed jets turn off after 2 hours. However, if users wish to manually turn off a hot tub’s jets, they can do so. Usually, there is a designated jets button on the hot tub. This button should be pressed until the jets begin to turn off.

Why is the Jets indicator light off on my Balboa pump?

Usually you will also notice the Jets’ indicator light remains off even when the Pump is running the low speed (indicator light should always be ON when the Pump is running) and if you press the Jets’ button, a humming noise can be heard and the Pump will completely shut off.

How to troubleshoot a Balboa hot tub pump?

Connect the power plug to an electrical outlet. Make sure there is electricity running to the outlet. Clear out the air tubes running from the pump to the hot tub. Any debris lodged within the tube should be removed with a pipe cleaner. Make sure the hose is running smoothly and isn’t kinked or trapped under something.

When do Master Spa hot tub jets come out?

Plus, Master Spa Parts typically ships same day if order is placed before 3pm CST, so you can have your hot tub up and running again in no time. While frustrating, an issue with your hot tub jets or pump isn’t the end of the road for your hot tub.

What to do if your Balboa hot tub is not working?

Before you call out a Balboa service technician, though, try to do some troubleshooting with your Balboa hot tub parts. Much of what can go wrong with a hot tub is in the pump. Try to identify the problem you are experiencing before attempting to correct a misbehaving part.

Is the Balboa spa filter pump supposed to shut off?

We have a Balboa Spa with a “Lite Leader” control. It runs properly, maintains temp properly, however the filter pump never cuts off. It is supposed to shut off, as it always has before…until now. It only has the 2 button top control…and is non-programable.