How do I reset my Atwood RV water heater?

How to Reset the Atwood Eco

Turn off the power on the Atwood Eco water heater.
Pull the junction box cover away from the water heater.
Push the reset button in with your finger until it clicks into place.
Place the junction box cover back onto the Atwood Eco and secure with the retaining nuts.

What color flame should water heater be?

The flame of any natural-gas appliance should be blue in color (with maybe a little yellow at the very tip of the flame). The orange flame of your water heater indicates that the gas is not combusting efficiently, and it’s a sure sign that your heater needs adjustment or repair.

Do you sanitize RV water heater?

At a minimum you should sanitize the system every spring when you take the RV out of storage and any time you notice stale water or an odor. Remove the plug and open the pressure relief valve on top of the water heater to assist in draining. CAUTION: NEVER drain the water heater when it’s hot or under pressure.

Can I put bleach in my RV hot water heater?

You’ll need 1/4 cup of bleach for every 16 gallons of water in your freshwater tank. Don’t add the bleach straight to your freshwater tank. You should dilute it first. Take that amount of bleach you’ve calculated for your specific RV and add it to at least a gallon of water.

Why is there no flame on my RV water heater?

If the unit clicks but there is no flame, it might mean there is a clog or blockage in the system. When RV water heater troubleshooting, check to verify the area near the water heater is cleaned out and free of debris. The final thing to look at is the flame.

What to look for when troubleshooting RV water heater?

When conducting RV water heater troubleshooting you will also want to check the exhaust to ensure that there are no obstructions that will impede the flow of gas into the water heater, or from the exhaust back out. Light the water heater and make certain there is a nice blue flame in the center with darker blue closer to the outside of the flame.

Why does my RV water heater make a clicking sound?

When the unit turns on will you will hear a clicking sound. If the unit clicks but there is no flame, it might mean there is a clog or blockage in the system. When RV water heater troubleshooting, check to verify the area near the water heater is cleaned out and free of debris. The final thing to look at is the flame.

What makes a gas water heater not catch on fire?

Most of today’s gas water heaters are equipped with the FVIR or Flammable Vapor Ignition Resistant technology and unique flame-arrestor feature, which prevents the flame and burning vapors to escape the combustion chamber, risking the open fire and potentially – explosion.

Why is my Atwood RV water heater not working?

One of the most common problems with Atwood RV water heater is a pilot outage. This can happen if you have a weak gas control magnet or if the thermocouple needs to be replaced. For poor pilot flame, you would need to replace the orifice. If it is not too old hen you can try cleaning the orifice and see how it goes.

What causes pilot outage on Atwood water heater?

A blocked U-tube can also cause pilot outage. Clean the tube and get rid of any obstruction there is. You should check the gas pressure and ensure it is in accordance with the recommendation of the manufacturer, in this case, Atwood.

What should I do if my water heater flame is not working?

If the venting system is blocked, clean it and make sure that air and flue passageways are free of deposits and debris. If the problem is with the high gas pressure, call the utility company. One possibility is water in the gas line due to pipe corrosion. If the problem is with the cold or excess draft, find the cause and fix the problem.