How do I reset my Aquatrol Hayward?
When the instant salt level is stable (and the negative sign still present), cycle slide switch to ‘Super Chlorinate’ and back to ‘Auto’. To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds).
How do you calibrate Aquatrol?
The calibration screen will start counting down from a higher salt reading than what the actual level in the pool water is. Once you see your salinity level, push the switch up to “super chlorinate” and then immediately back down to the “Auto” position. It is now calibrated.
How long do Hayward salt cells last?
3-5 years
It’s important to note, properly maintained salt cell will last 3-5 years; an improperly maintained cell can fail in a year.
How to troubleshoot your Hayward Aqua rite salt system?
Troubleshooting and diagnosing their problems. If you’re reading this blog that means you need help troubleshooting your Hayward Aqua Rite salt system. Well, the good news is you are at the right spot and you’re definitely not alone. This blog is an in-depth look at the Aqua Rite and Aqua Rite XL diagnostics manual created by Hayward.
Why is the no flow LED illuminated on Hayward Aqua Trol?
The Aqua Trol only generates chlorine when the filter pump is running, the main switch is in the “AUTO” or “SUPER CHLORINATE” position, and none of the red fault LEDs are illuminated. Why is the “No Flow” LED illuminated?
How to check time on Hayward Aqua Trol?
Check that the time clock manual switch is in the “auto” (center) position or in the “on” (top) position. If in “auto”, then check that the time is correct (check am/pm by using the 24 hour indicator located near the 2 o’clock position) and that the trippers are in the “out” position. Why is the “Generating” LED not on?
What causes the Aqua Trol to stop working?
Filter pump switched off or filter pump time too short ( 8 hours for average size pool, more for large pools) Salt level too low (below 2500 ppm, Low Salt LED on) Very warm pools increase chlorine demand- increase Desired Level % or filter run time. Cold water (below 50F) causes Aqua Trol to stop generating (Generating LED flashing).
How big of a pool do you need with Hayward aquatrol?
Designed for above ground pools up to 18,000 gallons, Hayward’s W3AQ-TROL-RJ AquaTrol Salt Chlorination System automatically converts salt into chlorine, naturally. You no longer have to worry about mixing, measuring or handling harsh liquid or tablet chlorine.
What kind of salt system does Hayward use?
Hayward’s AquaTrol Salt Chlorination System is designed specifically for above-ground pools up to 18,000 gallons and creates silky soft water that won’t irritate eyes, dry out skin or cause fabrics to fade. AquaTrol offers all of the same functions and features of Hayward’s AquaRite salt systems, but with lower chlorine output.
Troubleshooting and diagnosing their problems. If you’re reading this blog that means you need help troubleshooting your Hayward Aqua Rite salt system. Well, the good news is you are at the right spot and you’re definitely not alone. This blog is an in-depth look at the Aqua Rite and Aqua Rite XL diagnostics manual created by Hayward.
When to use high salt on Aqua Trol?
The High Salt LED will be ON when the cell amperage is above the maximum limit. High Salt LED will also be ON if the control is set for the wrong Turbo Cell type. Check to make sure the cell installed is a T-Cell-5. The LCD display will read “HI”. Verify salt level is 2700-3400ppm and check with independent test to ensure accuracy.
