How do I reset my Aquarite salt?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
Why does a salt cell stop working?
Salt cells fail for a few different reasons, the main reason being lack of proper maintenance. It is very important to check the cell regularly for excessive buildup. Use a cleaning kit designed for salt cells to keep the plates clear of buildup. Another common cause of salt cell failure is improper water balance.
How to turn off the chlorinator on aquarite?
If the incorrect cell is chosen the salt level, amperage, and voltage will not be correct and the system will turn the chlorinator off. Slide the Main Switch to the “Auto” position. Super. Chlorinate Auto Off Push the diagnostic button until “t-xx” appears on the display.
How to reset the average salt level on aquarite?
How to Reset Average Salt Level The Average Salt level needs to be reset for start up and when a cell is replaced. (factory default is 2800ppm) To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds).
How to reset salt level on Hayward Aqua rite?
To reset the average salt level, turn the unit off and then back to Auto. Wait for the relay to click (between 5 – 10 seconds). Now, press the Diagnostics button 5 times to display the Instant Salt level on the LCD screen.
How to reset the inspect cell led on aquarite?
To manually reset the Inspect Cell LED, press and hold the Diagnostics button until LED goes out (approximately 3 to 5 seconds).
How to troubleshoot your Hayward Aqua rite salt system?
Troubleshooting and diagnosing their problems. If you’re reading this blog that means you need help troubleshooting your Hayward Aqua Rite salt system. Well, the good news is you are at the right spot and you’re definitely not alone. This blog is an in-depth look at the Aqua Rite and Aqua Rite XL diagnostics manual created by Hayward.
How to Reset Average Salt Level The Average Salt level needs to be reset for start up and when a cell is replaced. (factory default is 2800ppm) To reset, turn the unit to Off and then back to Auto. Wait for the relay to click (5 to 10 seconds).
If the incorrect cell is chosen the salt level, amperage, and voltage will not be correct and the system will turn the chlorinator off. Slide the Main Switch to the “Auto” position. Super. Chlorinate Auto Off Push the diagnostic button until “t-xx” appears on the display.
What to do if there is no voltage on aquarite?
If voltage is good, go to step D. If no voltage, check to see that breaker and/or time clock are not off. Check input jumpers for correct position. 220-240 VAC: jumpers on 2 & 3 (factory default) 115-125 VAC: jumpers on 1 & 2 and 3 & 4 HAYWARD verify 20-24 VAC between yellow wires 085013H.2 T If no voltage go to step E.
