How do I reset my aqua rite?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
Why is my Aqua rite pool not generating chlorine?
The Aqua Rite has sensed a no flow condition and has stopped generating chlorine. unit and that the wire is not cut or damaged. Make sure you have at least 12″ of straight pipe before the flow switch. If there is adequate flow and the LED is still on, check that
Why are the lights not flashing on my Aqua rite pool?
1. “Power” LED not on screw terminals at the Aqua Rite control. Verify input voltage with a voltmeter. If there is input power, the fuse may have blown. The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector. 2. “Generating” LED flashing
What to do if your pool light is not working?
Prepare to add liquid chlorine to pool (don’t wait!) If unsuccessful, consider swapping out less expensive parts – flow sensor etc before replacing the board and/or cell once again. 1. “Power” LED not on
How to troubleshoot your Hayward Aqua rite salt system?
Troubleshooting and diagnosing their problems. If you’re reading this blog that means you need help troubleshooting your Hayward Aqua Rite salt system. Well, the good news is you are at the right spot and you’re definitely not alone. This blog is an in-depth look at the Aqua Rite and Aqua Rite XL diagnostics manual created by Hayward.
What should I do if my Aqua rite pump is not working?
The temperature of the pool water is too high or too low to operate. Override this by moving the Main Switch to Super Chlorinate. The Aqua Rite runs at maximum out for for the remainder of the current pump cycle or for 24 hours, whichever comes first.
What do you need to know about the aquarite pool?
A PCB Input Power (120/240VAC) B Transformer Input (120VAC & 120VAC) C External Control Jumper D Display Output (5-10VDC) E Rectifier Output (18-33VDC) F Comm Block – External Control (5-10VDC) G Transformer Output (12 VAC) H Chlorinator Fuse (20A – ATO style) I Rectifier Input (12 VAC) J Cell Input/Output K Flow Switch Input/Output F
Why is the high salt light on on my Aqua rite?
High Salt LED is also on if the control is set for the wrong Turbo Cell type. The LCD screen will read “HI”. Verify that the salt level is 2700 – 3400 ppm. We recommend that you check the salt level with a water test kit to ensure accuracy.
