How do I reset my Aqua Rite salt Cell?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
What does it mean when it says check salt cell?
If both the “check salt” and the “inspect cell” lights stay on, it most likely means that no chlorine is being produced at this time and your salt level fell below 2300 ppm. Both lights will also stay on if the controller is set to the wrong turbo cell type, or if the cell is unplugged.
What should intelliChlor be set at?
What should the salt level be? The intellichlor is set to function when the salt level is between 2800 ppm and 4500 ppm. Too little, it cannot make chlorine. Too much salt and it also cannot (should not) make chlorine and can cause additional voltage issues with your pool and equipment.
When do Check salt and inspect cell LEDs flash?
Solution: The Check Salt & Inspect Cell LEDs will flash at the same time when the salt level is between 2500-2600 ppm. Chlorine is still being produced when the lights are flashing. When these LEDs are ON, the salt level is 2300 ppm or below. This also means that chlorine production has stopped.
Why is the high salt light on on my Aqua rite?
High Salt LED is also on if the control is set for the wrong Turbo Cell type. The LCD screen will read “HI”. Verify that the salt level is 2700 – 3400 ppm. We recommend that you check the salt level with a water test kit to ensure accuracy.
Why is my Aqua rite cell light not working?
It is only 3 years old so can’t imagine it would already be gone out. With Leslies saying that the cell is ok, it appears as if the Aqua Rite isn’t reading the salt level properly and therefore isn’t generating chlorine.
How to reset aquarite salt chlorination inspect cell light?
Reset AquaRite Salt Chlorination Inspect Cell Light. If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
Solution: The Check Salt & Inspect Cell LEDs will flash at the same time when the salt level is between 2500-2600 ppm. Chlorine is still being produced when the lights are flashing. When these LEDs are ON, the salt level is 2300 ppm or below. This also means that chlorine production has stopped.
High Salt LED is also on if the control is set for the wrong Turbo Cell type. The LCD screen will read “HI”. Verify that the salt level is 2700 – 3400 ppm. We recommend that you check the salt level with a water test kit to ensure accuracy.
It is only 3 years old so can’t imagine it would already be gone out. With Leslies saying that the cell is ok, it appears as if the Aqua Rite isn’t reading the salt level properly and therefore isn’t generating chlorine.
Reset AquaRite Salt Chlorination Inspect Cell Light. If the Inspect Cell Light is the only LED light flashing, then you can reset it by simply holding down the diagnostic button for 3 seconds, then release. The Inspect Cell indicator will now reset and will later come back on after another 500 hours of use.
