How do I reset my Aqua Rite board?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do I reset my Hayward Aqua plus salt?
Turn the filter pump on. You must reset the system by entering the ‘Diagnostic Menu’ and then hitting the right arrow key once and then pushing the plus key once. This should reset the light and message.
How to recalibrate your Hayward Aqua Rite system?
How To Recalibrate The Average Salt Level To reset your average salt level, turn the unit to OFF and then back to AUTO. Wait for the relay to click (5 to 10 seconds). After the click, immediately push the diagnostic button 5 times to begin the recalibration stage.
Why is the high salt light on on my Aqua rite?
High Salt LED is also on if the control is set for the wrong Turbo Cell type. The LCD screen will read “HI”. Verify that the salt level is 2700 – 3400 ppm. We recommend that you check the salt level with a water test kit to ensure accuracy.
What should I do if my Aqua rite pump is not working?
The temperature of the pool water is too high or too low to operate. Override this by moving the Main Switch to Super Chlorinate. The Aqua Rite runs at maximum out for for the remainder of the current pump cycle or for 24 hours, whichever comes first.
How to troubleshoot an aqua rite with a fuse?
Power LED Not On 1 Make sure that either 120VAC or 240VAC input power is connected to the proper screw terminals at the Aqua Rite control. 2 Verify input voltage with a voltmeter 3 If there is input power, the fuse may have blown. 4 The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector.
How To Recalibrate The Average Salt Level To reset your average salt level, turn the unit to OFF and then back to AUTO. Wait for the relay to click (5 to 10 seconds). After the click, immediately push the diagnostic button 5 times to begin the recalibration stage.
Power LED Not On 1 Make sure that either 120VAC or 240VAC input power is connected to the proper screw terminals at the Aqua Rite control. 2 Verify input voltage with a voltmeter 3 If there is input power, the fuse may have blown. 4 The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector.
When did my Aqua rite PCB get damaged?
Probably happened in the spring during one of our thunderstorms. I called technical support at Goldline Controls (now part of Hayward) @ 908-355-7995. The helpful rep walked me through pushing the little test button to the left of the LCD display and I read him the readings it displayed.
The temperature of the pool water is too high or too low to operate. Override this by moving the Main Switch to Super Chlorinate. The Aqua Rite runs at maximum out for for the remainder of the current pump cycle or for 24 hours, whichever comes first.
