How do I remove a sink drain pipe from the wall?
Cut the PVC pipe at any point inside the wall that allows you to remove the stub-out, using a hacksaw. You may have to make two cuts to separate the tee holding the stub-out from the waste and vent pipes. Remove any clamps holding the stub-out with a screwdriver or hammer, and pull out the stub-out.
What is a drain flange?
A bathtub drain flange is the finished drain part that’s visible in the tub. Some manufacturers refer to the drain flange as a “drain body” or “drain basket”. Between the underside of the flange and the tub surface, there’s a good amount of plumbers putty that seals the inside of the drain.
How does a sink flange work?
The sink drain flange is a flat metal disk which fits into the drain hole at the bottom of the sink. It usually has a patterned grid over the hole, rather like a strainer. The flange holds the drain up to the sink, and is connected to the former by a straight piece of pipe called a tailpiece.
How do you replace the flange on a bathroom sink?
Turn off the water valves at the back of the sink and place a bucket underneath the drain to catch any water that may run out. Loosen the nuts that hold together the drain tailpiece and the P-trap with a wrench. Disconnect the the two pieces. Unscrew the drain tailpiece from the drain flange.
How can I remove a stuck drain flange?
Got a one piece metal tailpipe and need to free a stuck flange? Here’s a cheap trick that will help you grip the flange from the inside and provide enough resistance to remove it without destroying the flange or the sink. Using a piece of rubber from an tire tube wrap a socket and insert it into the flange. Loading…
How to fix drain pipe in bathroom sink?
4– Spin the nut all the way down or off of the threads. 5– Insert the drain back into the sink hole and be sure it is centered. 6– Install the nut and the sealing washer and tighten. (The excess putty will ooze out under the top flange until it is fully seated to the sink) 7– Remove the excess putty from in the sink.
How do you remove retaining nut from bathroom sink?
To start, make sure that the retaining nut is off. This is in the sink drain basket. To proceed, you’ll need to use a pair of pliers to remove the securing nut from the basket. One thing that may happen during this step is that the sink drain could spin while removing the nut.
Turn off the water valves at the back of the sink and place a bucket underneath the drain to catch any water that may run out. Loosen the nuts that hold together the drain tailpiece and the P-trap with a wrench. Disconnect the the two pieces. Unscrew the drain tailpiece from the drain flange.
Got a one piece metal tailpipe and need to free a stuck flange? Here’s a cheap trick that will help you grip the flange from the inside and provide enough resistance to remove it without destroying the flange or the sink. Using a piece of rubber from an tire tube wrap a socket and insert it into the flange. Loading…
4– Spin the nut all the way down or off of the threads. 5– Insert the drain back into the sink hole and be sure it is centered. 6– Install the nut and the sealing washer and tighten. (The excess putty will ooze out under the top flange until it is fully seated to the sink) 7– Remove the excess putty from in the sink.
To start, make sure that the retaining nut is off. This is in the sink drain basket. To proceed, you’ll need to use a pair of pliers to remove the securing nut from the basket. One thing that may happen during this step is that the sink drain could spin while removing the nut.
