How do I read my Raypak serial number?
The serial number will have 10 digits. The date code is found in the first four digits of the serial number, for example, a unit made in April of 2001 will have the first four digits read as 0104.
What does SNS mean on a pool heater?
SNS indicates that the Temperature Sensor is out of range! There are two thermistors within that sensor, and if there is a difference of 2 degrees, the board will throw a Fault Code: SNS. check for good connection at board, and ensure the sensor is all the way seated properly in its well. otherwise, it may be bad.
What does Lo mean on a pool heater?
Generally, LO refers to the pressure switch, water pressure. This can be caused by either the diaphram in the flow switch has failed or the filters is clogged and/or pump is unable to make enough pressure to make the switch.
Do you need to troubleshoot a Raypak pool heater?
Effective Raypak pool heater troubleshooting is all about knowing what to look for, and what the signs mean. Although all pool heat pumps need maintenance to maintain performance, a bit of troubleshooting can save you a lot of time. When you know what’s causing a problem with your pool heater, then fixing it is way simpler.
What does BD1 mean on a Raypak heater?
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)
Where do I find the fault code on my Raypak pool?
They are also equipped with onboard diagnostic controls. If there is a safety fault, a fault code will be displayed along with a service indication. (see pic on right) The word “SERVICE” will flash on and off if the PC board detects a known issue. The fault code is displayed in 3 big letters in the lower left of the display.
When does the fault code appear on a Raypak heater?
Raypak Heater Fault Code Guide 1 Water temperature is below 36F or above 110F 2 If the two thermistors are more than 2 degrees apart, the SNS code will appear. 3 Loose or corroded connection at P1. 4 If the sensor is not mounted all the way into the JACO fitting on the header, it may give a false reading.
The panic really doesn’t set in until you realize error code BD1 means absolutely nothing to you. Error codes are both curses and blessings. Although an error message is never really a good thing, at least it’s an indication of what the problem is. Just imagine how much easier it would be to diagnose diseases if humans came with error codes.)
Why does my Raypak pool heater need maintenance?
While pool heat pumps are built to provide countless hours of heat, they still need maintenance to stay at peak performance. After heating thousands of gallons of water, certain parts in your pool heater may begin wearing down.
